Bosch CSG636B 3 Series Manuale d'uso - Pagina 20

Sfoglia online o scarica il pdf Manuale d'uso per Forno Bosch CSG636B 3 Series. Bosch CSG636B 3 Series 44.

Bosch CSG636B 3 Series Manuale d'uso
en Basic settings
Press
to start the operation.
5.
a The appliance starts to heat and the time starts to
count down.
Once the cooking time has elapsed, an audible sig-
6.
nal sounds. The cooking time is at zero. The appli-
ance stops heating up and responds again as usual
outside of Sabbath mode.
15  Basic settings
You can configure the appliance to meet your needs.
15.1 Overview of the basic settings
Here you can find an overview of the basic settings
and factory settings. The basic settings depend on the
features of your appliance.
Basic setting
Language
Clock
Water hardness
→ "Before using for the
first time", Page 11
Factory setting
Audible signal
Volume
Button tone
Display brightness
Clock display
Lighting
Operation after switch-
on
Night-time dimming
Brand logo
Factory setting (may vary according to model)
1
20
Selection
See selection on the appli-
ance.
Clock in 24-hour format.
00 (softened)
01 (soft)
02 (med.)
03 (hard)
1
04 (very hard)
Reset
1
Do not reset
Short duration (30 seconds)
Medium duration (1 minute)
Long duration (5 minutes)
5 settings
Switched on
Switched off (tone remains
1
for
⁠ )
5 settings
Off
1
Digital
Analogue
Off during operation
1
On during operation
Main menu
1
Types of heating

Steam

Assist

1
Switched off
Switched on
1
Display
Do not display
Press
The appliance automatically switches off after ap-
prox. 10 to 20 minutes.
Basic setting
Fan run-on time
Pull-out system

Sabbath mode

1
Factory setting (may vary according to model)
15.2 Changing the basic settings
Requirement: The appliance is switched on.
Press
1.
Press "Basic settings".
2.
Press the required basic setting and use the control
3.
ring to change it.
1
The red bar next to the text field identifies the basic
setting that is currently selected. Its corresponding
value is shown in the display.
Use "Further settings" to scroll through the basic
4.
settings and, if required, use the control ring to
change any of these settings.
To save your changes, press
5.
to confirm.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
Discarding changes to the basic settings
Press
a All changes will be discarded and not saved.
15.3 Setting the time
Requirement: The appliance is switched on.
Press
1.
Press "Basic settings".
2.
3.
Press "Time".
Use the control ring to change the time.
4.
To save your changes, press
5.
to confirm.
to switch the appliance off.
Selection
Recommended
Minimum
Not retrofitted (if shelf sup-
ports and a single set of
pull-out rails are fitted)
Retrofitted (if two or three
sets of pull-out rails are fit-
ted)
Switched on
1
Switched off
⁠ .
and use "Do not save" to confirm.
⁠ .
1
1
and use "Save"
and use "Save"