Electrolux 300 Series Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Electrolux 300 Series. Electrolux 300 Series 11. Front load dryer
Anche per Electrolux 300 Series: Manuale d'uso e manutenzione (39 pagine), Manuale di istruzioni per l'installazione (50 pagine), Manuale d'uso e manutenzione (28 pagine), Manuale d'uso e manutenzione (46 pagine)

HOW TO ASSEMBLE AND USE

Fig. 3

Fig. 4

Place the Enviro Steamer on its preheating/cool

down stand then press on/off switch and wait for

about 3-4 minutes (Fig. 5). Do not leave the device

unattended during the waiting period. CAUTION: Do

not leave the device standing on the floor. If you

notice the formation of a whitish "halo," it may be

removed using a normal decalcifying product or

with a few drops of vinegar.

As soon as Enviro Steamer emits steam, begin using

it, passing slowly over the surfaces to be cleaned.

This is the ideal method for thoroughly cleaning your

floor. To disinfect specific areas of the floor, leave the

steamer over the spot for a minimum of eight seconds,

but no more than 15 seconds.

WARNING: Never turn the floor steamer over, or on its side when using

steamer, or direct steam at any person or animal. Use only on

floors.

When Enviro Steamer no longer emits steam the water refill light will come on (F).

This means that there is no more water (this will happen after approximately 15

minutes of use). Place appliance on preheating/cool down stand, turn off (Fig. 5)

and unplug from the electrical outlet. Take off the cap, and refill. During refilling, be

careful not to touch the hot parts of the device. CAUTION: Cap and floorcloth may

be hot.

9. Replace cap, turn your Enviro Steamer on again and steam will start to be produced

as before.

(continued)

3. Rest the base of the Enviro Steamer on its floorcloth

as supplied, making sure that the edges are secured

over the base. Then tuck both ends of the floorcloth

under the cloth clips (Fig. 3). Do not use without a

floorcloth in place.

4. Unscrew the cap (D), insert funnel (J) and pour 2 mea-

sures of water using the measuring jug (I) (total 12

oz.) into the tank, then screw the cap back on.

NOTE: Do not overfill.

5. Now, plug the unit into an electrical outlet.

Fig. 5

On/Off