Electrolux EDH3684PDW Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Electrolux EDH3684PDW. Electrolux EDH3684PDW 24.
Anche per Electrolux EDH3684PDW: Istruzioni per l'installazione (4 pagine)

Electrolux EDH3684PDW Manuale d'uso
12
www.electrolux.com
5. To confirm the adjustment, press and
hold buttons (A) and (B) at the same
time for approximately 2 seconds.

8. BEFORE FIRST USE

Rear drum locks are
removed automatically when
dryer is activated for the first
time. Possible to hear some
noise.
To unlock the rear drum locks:
1. Switch on the appliance.
2. Set any programme.
3. Press the Start/Pause button.
Drum starts to rotate. Rear drum locks
are deactivated.
Before you use the appliance to dry
items:

9. DAILY USE

9.1 Start a programme without
delay start
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when
you close the door, the
laundry does not get
caught between the
appliance door and the
rubber seal.
2. Set the correct programme and
options for the type of load.
The display shows the programme
duration.
Real drying time will depend
on type of the load (quantity
and composition), the room
temperature and the
humidity of your laundry
after spin drying phase.
3. Press the Start/Pause touch button.
The programme starts.
• Clean the tumble dryer drum with a
moist cloth.
• Start a 1 hour programme with moist
laundry.
At the beginning of the
drying cycle (first 3-5 min)
there could be a slightly
higher sound level. This is
due to the compressor
starting up. This is normal
for compressor powered
appliances such as
refrigerators and freezers.
9.2 Starting the programme
with delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again
and again until the display shows the
delay time you want to set.
You can delay the start
of a programme from a
minimum of 30 minutes
to a maximum of 20
hours.
3. Press the Start/Pause touchpad.
The display shows the countdown of the
delay start.
When the countdown is completed, the
programme starts.
9.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
9.4 At the end of the
programme
When the programme is completed:
OFF