Bosch HBB74C 0 Series Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Forno Bosch HBB74C 0 Series. Bosch HBB74C 0 Series 24.

Stampa la pagina

ã=

Significant health risks!

Do not place non-stick baking tins or trays in the oven during

self-cleaning. The intense heat removes the non-stick surface

and creates toxic gases.

Setting

Once the cleaning level has been selected, set the oven.

Select the Self-cleaning

knob.

Set the required cleaning level using the

The display panel will show the cleaning level and the

symbol. Self-cleaning starts within a few seconds.

The oven door locks shortly after the function has started. The

symbol lights up on the display panel. Only when the

symbol turns off can the oven door be opened again.

Self-cleaning has ended.

The display panel will show

Turn the function control knob to the zero setting. The oven

switches off. The oven door can be opened again when the

symbol on the display panel turns off.

Changing the cleaning level

The cleaning level cannot be changed once it has started.

Care and cleaning

If cleaned and properly cared for, your oven will keep its bright

appearance and operating performance for many years to

come. Advice on how to care for and clean your oven is

provided below.

Notes

Different colours may be seen in your front panel due to the

■

various materials used in its manufacture, such as glass,

plastic and metal.

Dark patches in the door's glass panel may seem to be dirt

■

but they are in fact reflections from the oven light.

Enamel burns at very high temperatures. This may cause

■

slight discolouration. This is normal and does not affect the

oven's operation. The edges of thin baking trays may not be

completely enamelled. They may therefore feel slightly rough,

although their corrosive protection will be unaffected.

Cleaning products

Follow the information provided in the table to avoid damaging

the various oven surfaces by using unsuitable cleaning

products. Do not use

abrasive or acidic cleaning products,

■

strong products containing alcohol,

■

scourers or hard sponges,

■

high-pressure or steam cleaners.

■

Wash new cloths thoroughly before use.

function with the function control

sensors.

‹‹

. The oven will stop heating.

Stopping the self-cleaning

Turn the function control knob to the zero setting. The oven

switches off. The oven door can be opened again when the

symbol on the display panel turns off.

Delaying the end time

The oven allows you to programme the self-cleaning end time.

Self-cleaning can therefore be programmed at night for

example, leaving the oven free for use during the day.

Programme as described in section 1 and 2. Before starting the

self-cleaning, press the

end time with the

sensors.

The oven is set to standby. The display panel will show the

cleaning level and the

symbol. When self-cleaning starts, the

cleaning level and the

switches off.

Viewing the time settings

To view the duration of the cleaning level or the end time of the

self-cleaning press the

symbol lights up. The corresponding value will be shown for a

few seconds on the display panel.

After using the self-clean function

Once the inside of the oven has cooled, clean the ash remains

using a damp cloth.

Zone

Front panel

Stainless steel

Glass panel

Display

Glass panel

Door covering

sensor three times and delay the

symbol are shown. The

sensor repeatedly until the required

Cleaning products

Hot water and a little soap:

Clean with a dishcloth and dry with a

soft cloth. Do not use window

cleaner or a glass scraper.

Hot water and a little soap:

Clean with a dishcloth and dry with a

soft cloth. Immediately remove any

water marks, grease, cornflower or

egg white stains since corrosion

could occur underneath these marks

or stains.

Special products for the care of

stainless steel and which are

suitable for hot surfaces may be

obtained from Technical Assistance

Service centres and specialist retail

outlets. Use a very fine soft cloth to

apply the cleaning product.

Glass cleaning products:

Clean using a soft cloth. Do not use

a glass scraper.

Glass cleaning products:

Clean using a soft cloth. Do not use

alcohol, vinegar or other abrasive or

acidic cleaning products.

Glass cleaning products:

Clean using a soft cloth. Do not use

a glass scraper.

Only use products specially for

cleaning stainless steel (these can

be obtained from the Technical

Assistance Service or from specialist

shops). Follow the manufacturer's

instructions.

symbol