Bosch HBC24D533W Manuale di istruzioni - Pagina 16

Sfoglia online o scarica il pdf Manuale di istruzioni per Forno Bosch HBC24D533W. Bosch HBC24D533W 24.

Stampa la pagina

Problem

The evaporator dish has boiled dry even

though the water tank is full

The

indicator appears

There is a "pop" noise during cooking

When you cook with steam, a lot of steam

is created

When cooking with steam, a lot of steam is

created again

Steam escapes from the ventilation slots

during cooking

The appliance is not producing steam

properly

Error message

appears in the dis-

"‹‚‚

play

... error message appears in the dis-

play

The appliance is not heating. The colon

flashes in the display

Replacing the cooking compartment bulb

Heat-resistant 25 W, 220/240 V bulbs, E14 bulb sockets and

the seals are available from the after-sales service. Please

specify the E number and FD number of your appliance.

Risk of burns!

Allow the cooking compartment and cooking compartment light

to cool before changing the bulb.

Switch off the fuse in the fuse box or unplug at the mains.

Turn the cover anti-clockwise to remove.

Screw out the bulb by turning it anti-clockwise and replace

with a bulb of the same type.

Slide the new seals and the clamping ring onto the glass

cover in the right order.

Screw the glass cover with the seals back on again.

Connect the appliance to the mains and reset the clock.

Never operate the appliance without the glass cover and seals.

Replacing the glass cover or seals

Any damaged glass cover or seals must be replaced. Please

provide the after-sales service with the E number and FD

number of your appliance.

Possible cause

The water tank has not been pushed in

properly

The feed line is blocked

The appliance has not been used for at

least 2 days and the water tank is full

Cold/warm effect with frozen food, caused

by the steam

The appliance is being automatically cali-

brated

The appliance is unable to calibrate itself

automatically if cooking times are too

short

Limescale has formed in the appliance

A button was pressed for too long or is

jammed

Technical fault.

A button combination was actuated

Changing the door seal

If the seal around the outside of the cooking compartment is

faulty, it must be replaced. Replacement seals for your

appliance can be obtained from the after-sales service. Please

specify the E number and FD number of your appliance.

Open the appliance door.

Pull off the old seal.

Push in the new door seal at one point and pull it in all the

way round. The joint must be at the side.

Check again that the seal is correctly fitted in the corners.

Notes/remedy

Slide in the water tank until it engages

Descale the appliance. Check whether the

water hardness is set correctly

Empty and clean the water tank. Always

empty the water tank after cooking

This is normal.

Reset the appliance to the factory settings

(see Basic settings section). Then start

steaming at 100 °C for 20 minutes

This is normal.

Start descaling (see Section: Descaling)

Press the

button to clear the fault mes-

sage. Press each button and check that it

is clean

Press the

button to delete the error

message. Reset the clock if required. If the

error message appears again, call the

after-sales service

Set the Steam operating mode to 35 °C,

then press and hold the

signal sounds. Press the

briefly

button until a

button again