Electrolux EW 1066 T Libro di istruzioni - Pagina 20

Sfoglia online o scarica il pdf Libro di istruzioni per Lavatrice Electrolux EW 1066 T. Electrolux EW 1066 T 21.

Water connection

Connect the water inlet hose to a cold water tap

with a 3/4" gas threaded orifice, after having inserted

the rugger sealing washer into the hose collar

(fig.1). If the water connection is made onto new

pipes or onto pipes which have not been used for

a long time, it is advisable to run off a certain

amount of water before connecting the machine.

Place the curved end of the outled hose into a drain

Fig.1

pipe having a height between 70 and 100 cm from

floor level (fig.2) or secure it to a sink (fig.3). Make

sure that the drain hose is firmly secured so that it

will not slip out or fall down from its position.

The water should drain freely and, consequently,

the drain hose should not be choked or placed in

such a way as to obstruct the normal water flow.

If an extension hose is required, remember that it

might cause a malfunction in the drain pump,

Fig.2

Fig.3

particularly if the extension has a length in excess

of 1 meter or if the diameter of the extension is

smaller than the diameter of the original drain hose.

Before you fit the plug into the wall socket, check

the following points :

1) The supply voltage of the domestic wiring system

does not fluctuate by more that 10%, plus or

minus, from 230 V.

2) The meter, the fuses, the supply line and the wall

socket are suitable to carry the maximum load

required by the machine (2,3 kW).

Very important :

The washing machine is provided with a feeding

wire with earth connection: it must be

connected to a plug like that is provided with a

good earth connection. The wall plug must be

easily accessible.

The replacing of the power cord must only be

realized by the After Sales Service in order to

avoid any danger.

The manufacturer declines any responsibility

where the previous recommendations are not

followed.