Drazice OKC 160 NTR / BP Manuale di funzionamento e installazione - Pagina 10

Sfoglia online o scarica il pdf Manuale di funzionamento e installazione per Caldaia Drazice OKC 160 NTR / BP. Drazice OKC 160 NTR / BP 20. Stationary water heaters
Anche per Drazice OKC 160 NTR / BP: Manuale di funzionamento e installazione (17 pagine), Manuale di funzionamento e installazione (12 pagine), Manuale di funzionamento e installazione (20 pagine), Manuale di funzionamento e installazione (18 pagine), Manuale operativo e di installazione (20 pagine), Manuale di funzionamento e installazione (18 pagine), Manuale operativo e di installazione (13 pagine)

2 OPERATION AND FITTING INSTRUCTIONS

The tank shall only be used in accordance with the conditions specified on the performance

plate and in instructions for electric wiring.

regulations and standards, also conditions for connection defined in local electric and water

works have to be adhered to, as well as the installation and operation manual. The room, in

which the appliance will be operated, must be frost-free. The appliance has to be mounted

at a convenient place, it means that the appliance must be easily available for potential

necessary maintenance, repair or replacement, as the case may be.

We would like to emphasise that the heater must not be connected to power supply if

work involving flammable liquids (petrol, spot remover) or gases, etc., is performed

nearby.

If water is strongly calcareous we recommend that any of the common decalcifying devices

was installed with the appliance, or the thermostat to be set to minimum operation

temperature of 60

used. To avoid potential sediments we recommend that the device was installed together

with a water filter.

Prior to mounting, check the loading capacity of the wall and, depending on the type of

masonry, choose a suitable anchorage material, or reinforce the wall, if needed. The water

heater shall only be mounted in vertical position so that the lower edge of the heater was

placed at least 600 mm above the floor (Figure 1, Figure 2). In combined heaters, elbows

have to be attached to the heating water inlet and outlet and, by turning them, the

mounting either from the right or from the left has to be determined (Figure 4). With regard

to various types of carrying masonry and broad assortment of special anchorage material

available at the market, we do not provide heaters with this material. The anchorage system

has to be selected individually, depending on the conditions. We recommend an authorised

company perform mounting on the wall and anchorage, or discuss the anchorage with a

professional.

C. For proper operation, drinkable water of adequate quality shall be

Besides legally acknowledged national

- 10 -