Anchor Voyager Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti Anchor Voyager. Anchor Voyager 7. Portable sound system

Stampa la pagina

Operation

Voyager Control Panel
Mic 1 Input
(XLR jack)
Mic 2 Input
(1/4" phone jack)
Line Input
(
(1/4" phone jack)
Line Output
(1/4" phone jack)
LINE OUT
Speaker Output
(1/4" phone jack)
SPKR OUT
Charger Input
(use RC-16 only;
RC-16/220 for export)
CHARGER
Flashing = fully charged.
Charging Indicator
Operating the sound system
1. Set all input level controls to minimum before
turning on the power.
2. Plug a microphone into either Mic input jack
(depending on microphone and plug type), or
connect an audio source to the line input.
3. Turn power ON (red LED next to switch will light).
If the LED flashes or does not light, the battery must be
charged (see page 8).
4. Adjust the level control adjacent to the input used to
desired volume level.
5. Adjust the tone control for desired sound.
6
MIC 1
TX ON
CA
MIC 2
WIRELESS
)
LINE
TONE
On
Flashing =
low battery
Off
POWER
PB-3000W
MIC 1
Wireless
Reception
Indicator
(PB-3000W only)
MIC 2
(
)
WIRELESS
Tone Control
Power / Battery
Indicator
LINE
LINE OUT
SPKR OUT
Operation
Mic 1 Input
Balanced, low impedance XLR microphone input. Use with
a balanced microphone to help prevent hum or interference
when using long mic cables. It has phantom power for use
with condenser-type microphones.
Mic 2 Input
An unbalanced, low impedance microphone input. For use
with mics that have a 1/4" phone plug.
On PB-3000W (wireless) models, the built-in receiver is
connected to this input. Use the Mic 2 control to adjust the
wireless mic volume. (Inserting a plug into the Mic 2 input
disconnects the wireless input—to use a wired and wireless mic
simultaneously, plug the wired mic into the Mic 1 Input.)
Line Input
The line input (1/4"-phone jack) is used for playback of a
tape or CD player, musical instrument, VCR or similar
source. It may be used simultaneously with the mic inputs
for a composite output.
Note: All connections must be made with shielded cable to
avoid hum, buzzing, or radio interference.
Line Output
The output signal is a composite of all the inputs. Use it to
record your presentation, or to "daisy chain" another powered
sound system to the Voyager for greater crowd coverage.
Speaker Output
Use the speaker output to drive an unpowered 4-8Ω speaker
in addition to Voyager's built-in speakers for greater output.
N
: When an external speaker is powered by the Voyager,
OTE
battery service per charge will decrease considerably.
Speaker Stand Adapter
(use with 1.5" diameter stands)
1. Slide adapter into the slot on bottom of the Voyager.
2. Tighten screw to secure adapter to Voyager.
3. Place unit on stand, then tighten screw on the collar
of the adapter to secure Voyager to stand.
7