Anchor Navi-Trac Lite Manuale di istruzioni per l'installazione - Pagina 11

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Tenda Anchor Navi-Trac Lite. Anchor Navi-Trac Lite 20. Frame tent 30' wide system

Stampa la pagina

P-15 (HOOK END)

Attach the curved, hook ends of two drop-

in Purlins (P-15) to the purlin bracket of the

standing beam as shown.

COMPLETING AND STAKING THE HIP END FRAME

The final middle bay joins with the cross beam of the opposite hip end (see fig. 32 & 33). Position the second

(facing) hip end 15' from the last middle beam, and use Eave Bars (E-15), Purlins (P-15), and Ridge Bars w/

Hooks (RH-15) to connect it to the standing frame structure

THE LAST MIDDLE BAY

To finish out the unit, position a second, facing, hip end spaced 10'

from the last parallel middle beam and connect the purlins, ridge,

and eave bars just as in the preceding bay. Consult the blue print

for loading data for each baseplate location. Stakes alone may not

meet the loading requirement. It is the customer's responsibility

to provide adequate anchoring to meet the loads.

FABRIC GUIDE BRACKET

Fabric is installed using the fabric wheeled guide

brackets and pull ropes thrown over the purlins

and eave bars from one side of the tent to the

other (see fig. 34).

To install the hinged Wheeled Guide Bracket,

slide the top over the external eye of the eave

weldment and pin in place using a Tension Lock

Pin. Spread the hinged bottom brace until the

lower end lodges in the tensioning slot of the

upright leg, as shown to the right (see fig. 34 &

35).

Using the butterfly set screws attach the Navi-

Trac Wheeled Panel Guide wheels into the open

end of the bracket at the hinged angle, as shown

(see fig. 36).

P-15 (HOOK END)

LIFTING CRADLE

Using the long Eave Bar Cradle, lift and attach

the straight angled ends of the drop-in purlins

(P-15) to the purlin brackets of the new middle

beam.

STAKE ALL BASE PLATES

TOP OF BRACKET PINNED

TO THE OUTER EYE OF

THE EAVE WELDMENT

Fabric Kedar being fed between the angled

wheels of the panel guide.

Repeat this process with the Ridge w/Hooks

(RG-15) as shown above. Again, use the long

Eave Bar Cradle to attach the opposite end.

HIP END UNIT WITH

(2) MIDDLE BAYS

STAKE ALL GUY CABLES

ACCORDING TO LOADS

SHOWN ON THE BLUEPRINT.

Before installing fabric, all middle beams should be guyed

off, as shown. All guys are staked out from the upright at a dis-

tance equal to the height of the upright. If the breeze is strong,

the corner uprights should be guyed off as well. Later, the cor-

ner guys will be temporarily released while the fabric hip end is

being tensioned.

WHEELED PANEL GUIDE

TENSIONING SLOT

RG-15

NOTE: SEE APPENDIX 1,

FIG. 57 & 58 FOR X-CABLING

REQUIREMENTS IN UNITS

EXCEEDING 60' IN OVERALL

LENGTH

TOP OF GUIDE BRACKET

WHEELED PANEL GUIDE

BOTTOM OF GUIDE BRACKET