Dream Cheeky 389-IM-R1 Manuale - Pagina 2

Sfoglia online o scarica il pdf Manuale per Altoparlanti Dream Cheeky 389-IM-R1. Dream Cheeky 389-IM-R1 3.

Stampa la pagina

The Cube - Manual

CHARGING YOUR CUBE :

Fully charge the Cube before ﬁrst time use, which can take up to 1.5 hours.

1. Charge the Cube by plugging the charging cable into the mini USB charging

port of the Cube and into the USB port of your computer or power adapter.

2. The LED indicator will glow in red when the battery is charging.

3. The LED indicator will glow in green when the battery is fully charged.

USING THE CUBE WITH A BLUETOOTH ENABLED DEVICE

Introduction:

Volume up

Volume down

Phone

Establishing Bluetooth

Pair the Cube to a device

Enable

(Bluetooth

) on your smartphone, tablet, computer, or

laptop (following the steps in its respective manual) and make it search

for devices.

ii)

Turn on your Cube by holding the

notes from low to high).

iii)

The blue LED indicator will blink twice in intervals to indicate it's turned

on without being connected to a

iv)

Hold the

until you hear a sound (two notes from high to higher).

The blue LED indicator will start blinking fast to indicate the Cube is

searchable and ready to be paired with your

vi)

Wait for the Cube to show as "magic cube" in the list on your

enabled device.

vii)

Select "magic cube" to pair and connect. Once the connection is

established you'll hear one beep and the blue LED indicator will blink

three times in intervals.

viii)

You can now use the Cube as a speaker and/or microphone for your

device.

ix)

Turn off your Cube, by holding the

notes from high to low), to disconnect.

Make sure the sound on

the connected device is not

muted or too low to hear.

Connection

until you hear a sound (four

enabled device.

until you hear a sound (four

Reconnect the Cube to a paired device

The next time you want to connect the Cube to the same device, you

only have to turn on the Cube.

Connect the Cube to a new device

If you want to connect the Cube to another

On / Off

"magic cube" from the list on your

off, or disable its

(Pair the Cube to a device) for the new device.

Bluetooth

the Cube's audio jack port.

indicator will blink in different variations depending on the function.

select "magic cube" or "magic cube Stereo" in the sound settings of these

devices to tell the device to use the Cube as its speaker ("magic cube

Stereo") or microphone ("magic cube").

Operate the Cube

Press

been reached, you'll hear a beep. You can adjust the volume of the

connected device separately.

ii)

Press

the connected device separately.

iii)

Press

through.

iv)

Hold

Mini USB

charging port

enabled device, turn this device

function. Then follow the steps described above

to increase the volume of the Cube. When the maximum has

button to decrease the volume. You can adjust the volume of

shortly to pick up the phone when a phone call is coming

to reject an incoming phone call or to close a phone call.

#389 - IM - R1 / P.2

LED indicator

enabled device, remove