Anchor megavox Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti Anchor megavox. Anchor megavox 7. Portable
Anche per Anchor megavox: Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine)

Stampa la pagina

1. Replacing the Transmitter Battery

100-58-0/B MGX 2/6/01 9:49 AM Page 7

Feedback Information

What causes feedback?

Feedback is a ringing, howling, or shrill sound that is self-

generated by the sound system. It is the result of sound from

the speakers being picked up by the microphone(s) in use

and then re-amplified by the system. This can form a self-

sustaining loop that can damage the sound system if allowed

to continue.

How to prevent feedback

ALWAYS STAND BEHIND THE SPEAKER

WHEN USING A MICROPHONE.

CAUTION: Feedback can damage your equipment and may be

hazardous to your hearing. To avoid feedback, always make sure

volume controls are at minimum before turning unit on. If

feedback occurs, immediately reduce the volume.

Wireless Operation

Operating the wireless microphone system

The audio signal from the built-in wireless receiver is fed to

the MIC 2/WIRELESS input. Unplug any other mic from the

MIC 2 input when using the wireless system.

Operating the wireless microphone system:

1. If you are using the bodypack transmitter, insert the

plug from the mic into the jack marked "MIC" on the

transmitter.

2. Set the MegaVox's Mic 2/Wireless volume control to

minimum.

3. Turn the sound system power switch ON.

MIC

(WIRELESS)

4. Set the transmitter power switch ON. The sound

system's TX ON indicator lights to indicate wireless

signal (RF) is being transmitted and received.

5. Adjust the Mic 2/Wireless control to desired volume.

Caution: Harmful feedback may occur when walking in front of a

sound system or speaker with a wireless microphone. Always point

mic away from speakers.

Replacing the transmitter battery

Note: The transmitter power switch must be in the OFF position!

HANDHELD: Unscrew the battery compartment cover on

the lower end of microphone.

Observe proper

Install a fresh 'AA' alkaline battery

polarity when

and replace the cover.

installing the

battery!

BODY-PACK: Open battery

cover on the side of the

transmitter box and insert a

fresh 9 Volt alkaline battery. Close the cover.

(PB-35W)