Electrolux ESF 246 Libro di istruzioni - Pagina 11
Sfoglia online o scarica il pdf Libro di istruzioni per Lavastoviglie Electrolux ESF 246. Electrolux ESF 246 12. Electrolux dishwasher
Anche per Electrolux ESF 246: Libro di istruzioni (12 pagine)
Stampa la pagina
Installation
Positioning
In its standard version the machine is intended for instal-
lation on a kitchen sink or worktop. To function properly
the machine must be fully level. Its height can be adjusted
with the adjustable feet (8 mm each).
Water supply
The temperature of the water supply should not exceed
25° C and the pressure should be between 50-1000 kPa
(0,5 - 10 bar).
It is important to have a tap or stopcock, positioned close
to the dishwasher and with easy access. Special mixer
taps with dishwasher connections are available, as well
as adaptors for older mixer taps. Connect the inlet hose
to a tap with a 3/4" pipe thread.
The inlet hose must not be joined onto any form of exten-
sion hose. If it is too short, the entire hose must be repla-
ced with a longer high-pressure hose, specially designed
for the purpose. The end of the hose, which is connected
to the dishwasher can be turned in any direction. Loosen
the retaining nut, turn the hose, then retighten the nut.
Check that the nut is tight before the machine is
moved into position.
Use only the inlet hose supplied to the dishwasher,
do not reuse the old inlet hose.
Discharge connection
Place the discharge hose over the sink as illustrated.
It must not at any point be higher up than 75 cm over the
surface which the dishwasher is standing on. If it runs higher,
operation of the dishwasher might be impaired.
It is also important to ensure that the inside diameter of the
hose is not less than 13 mm at any point. If the discharge
hose is too long, it can easily be cut to the right length.
- Cut the hose to a suitable length, using a sharp
knife.
- Fit the elbow supplied onto the end of the hose.
Electrical connection
The dishwasher is supplied with a lead and electrical plug
for connection to a 230 V earthed wall socket, which should
be easily accessible and protected by a 10 A fuse.
Before any work is carried out on the dishwasher,
it must be isolated from the electric mains supply,
for example by removing the plug from the wall
socket.
Permanent electrical installation must be carried
out by an authorized electrician or competent
person.
- 11 -