Forme Whisper Manuale
Sfoglia online o scarica il pdf Manuale per Riscaldatore Forme Whisper. Forme Whisper 2. Wall fan heater
Stampa la pagina
Forme Whisper – Wall Fan Heater
The Forme Whisper Wall Fan Heater is a metal bodied heater
ideal for bathrooms, kitchens and areas requiring localised,
controllable heat. The Forme Whisper features a variable
thermostat, with a frost protection setting, for increased
economy, pullcord operation, automatic overheat safety cut-
out and a power-on indicator light. For ease of installation it is
fitted with a 0.9m cable.
Features:
Thermostatic control • Pull-cord operation • Automatic
safety cut-out • Power-on indicator Fitted power supply
cable • Fixing/Securing bracket • Finished in Crisp White or
stainless • 190(h) x 115(d) x 300(w) mm
Installation
Ensure that the electricity supply is disconnected from any relevant fixed wiring before commencing the
installation. Ensure that the mains supply voltage is as stated on the rating label. The supply circuit must be
adequate for the input of the appliance. This unit must be installed by a registered electrician. The installation of
this product must comply with NZS 3000.2007.
• The appliance should be fitted horizontally such that the cable entry is uppermost and the pullcord is at the
bottom.
• The unit must be mounted a minimum of 1.8m from the floor, also a minimum of 150mm below ceiling level or
any other projecting surface. It must also not be less than 250mm from any adjacent projecting surface.
• The unit must not be located immediately below a fixed socket outlet.
• Ensure that when in use the airstream is not obstructed by a cupboard or similar object.
• Do not attempt to repair the heater or unscrew the outer casing yourself.
• Do not place aerosols or similar containers or materials susceptible to heat in the direct airstream.
Mounting Procedure
• Using the mounting bracket supplied as a template, position it
horizontally at a minimum of 1.92m from the floor to the underside
of the bracket and mark the position of the three fixing holes (Ref A
in diagram)
• Drill and plug the wall suitable of No. 8 screws
• Insert the two keyhole screws in the wall leaving approximately 2mm
gap between head and wall.
• Secure the mounting bracket to the appliance using the three No. 6
screws supplied (Ref B in diagram)
• Position the appliance on the partially inserted wall screws and
secure the third wall screw immediately above the appliance.
Controls
The Forme Whisper has a heat loading of 2kW. The heater is controlled by a pullcord operated on/off switch. A
neon indicator when lit shows that the unit is operational.
The appliance is fitted with an Electronic Safety Control (ES). This is a safety device which switches off the heater if
for any reason the appliance overheats. The ES control can only be re-set after the appliance has cooled down. In
order to re-set the ES Control proceed as follows:
• Switch off appliance by means of pullcord and leave for approximately 5 mins
• Switch appliance back on and ES control will re-set
• Ensure that the appliance is functioning correctly. Is the ES Control operates again, the appliance should be
checked by a registered electrician.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched
on and off by the utility.
Thermostat
Control Knob
Outlet
Grille
Inlet
Grille
Neon
Indicator
Switch
Pullcord