Carmanah SPEEDCHECK Manuale di sostituzione - Pagina 8
Sfoglia online o scarica il pdf Manuale di sostituzione per Controllore Carmanah SPEEDCHECK. Carmanah SPEEDCHECK 10. For the solar-powered speedcheck-15/18 radar speed signs
Anche per Carmanah SPEEDCHECK: Manuale di sostituzione (11 pagine), Manuale di sostituzione (10 pagine)
Stampa la pagina4.0 Capacitor Removal
This section is only required if your system has a large capacitor installed in one of the following locations:
•
SPEEDCHECK-15 – installed in the bottom right corner of the sign enclosure
•
SPEEDCHECK-18 – installed on the rear back panel of the sign enclosure
The capacitor needs to be removed after installing the replacement controller.
Do not short the two capacitor wires together as this can short out the capacitor and cause
physical harm or burns.
4.1
SPEEDCHECK-15 Capacitor Removal
1. Remove the capacitor wires from the terminal blocks. Cap off each wire one at a time with wire nuts after
they are removed.
2. Remove the nyloc nut and fully remove the capacitor from the system.
3. Close all fuse blocks and ensure battery voltage is passing through to the SpeedCheck control board
inside the SPEEDCHECK-15.
4. Reassemble system.
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
SOLAR CHARGE CONTROLLER
REPLACEMENT GUIDE
Fuse holder
Capacitor positive
wire (red)
Capacitor negative
wire (black)
Nyloc nut
Capacitor
|
carmanah.com
8