Dreaming Robots Camera Axe 5 Manuale d'uso - Pagina 16

Sfoglia online o scarica il pdf Manuale d'uso per Camera Accessories Dreaming Robots Camera Axe 5. Dreaming Robots Camera Axe 5 20.

Parameter

Trigger Sensor

Delay ms

Bulb sec

Prefocus

Device Settings

Parameter

Trigger Type

Trigger Value

Power

Sensor Settings

The camera should be set to manual mode and the aperture and shutter speed should be set as

appropriate for the flash value. The delay for Device 2 (the flash) is to allow the shutter on the camera

to open before the flash triggers. The Power setting of Off_Sen2 turns the laser off before the camera

is triggered to keep the laser beam from being in the shot. The shot will be triggered when the light

sensor value goes below 100 (this value may need to be adjusted up or down depending on the

sensor reading when the laser is on verses off the light sensor).

Microphone Sensor

The microphone sensor is a basic sound activated sensor that is used to trigger devices based on

sharp/loud sound changes. An example of how the microphone sensor would be used is described

below.

Using a microphone sensor plugged into the Sensor 2 port and a flash connected to Camera/Flash

1, the user would like the flash to trigger 1/2 second after the microphone triggers. The following

settings could be used to set this up. In this case the settings for Device1 and Sensor2 are configured

according to the table below. Device2 should have the Trigger Sensor set to None and Sensor2 will

be ignored.

Parameter

Device 1

Device 2

Sensor1

000.0

000.2

Sensor1

Sensor2

Low

100

000

Off_Sen2

Device 1

Device 2