Bosch Instructions for Use Manuale di installazione e istruzioni per l'uso - Pagina 12

Special programmes

Fluff Clean

This programme is designed to clean the drying cycle of any fluff

deposits. After 10 drying cycles, the washer-dryer uses the symbol

(Fluff removal cycle) in the display panel to show that this programme

should be run. The electronic cycle counter is then automatically reset.

The

(Fluff removal cycle) symbol goes out after the programme starts.

To run the Fluff Clean

Make sure that the drum is completely empty and close the door.

Set the programme selector to Fluff Clean

Press the A (Start/Pause) button.

You can also run the Fluff Clean

prompting from the appliance.

' + B Rinse + Spin

An additional rinse cycle with a final spin. If the laundry is to be removed

dripping wet, set the spin speed to $ (Rinse stop) before starting the

programme → page 13.

[+ B Drain + Spin

Drain the rinsing water following a programme with $ (Rinse stop)

→ page 13.

Turn the programme selector to

Set the spin speed to $ (Rinse stop).

Press the A (Start/Pause) button.

Drain and spin at the desired spin speed:

Turn the programme selector to

Press the B (Spin) button repeatedly until the desired spin speed is

set.

Press the A (Start/Pause) button.

programme, proceed as follows:

programme at any time without

[+ B

Drain + Spin.

[+ B

Drain + Spin.