Bosch Instructions for Use Manuale di istruzioni - Pagina 7

Stampa la pagina

Bosch Instructions for Use Manuale di istruzioni

Installation

– Scope of delivery: dryer, installation and operating instructions.

– Check dryer for transport damage.

– The dryer is very heavy. Do not attempt to lift it on your own.

– Be careful to avoid sharp edges.

– Do not set up in a room that is susceptible to frost. Freezing water may cause damage.

– If in doubt, have the appliance connected by a specialist.

– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.

Setting up the dryer

– The appliance plug must always be accessible.

– Ensure that the appliance is installed on a clean, level

and firm surface.

– Do not obstruct the air inlet on the front of the

dryer.

– Keep the area around the dryer clean.

– Make the dryer level using the threaded feet

and a spirit level.

– Do not remove the threaded feet under any

circumstances.

Do not set up the dryer behind a door or sliding

door, as this may obstruct the dryer door or prevent

it from opening. This will prevent a potentially fatal

danger to children from locking themselves in.

Mains connection

see Safety instructions

– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.

– The mains voltage and the voltage shown on the rating plate (

same.

– The connected load and necessary fuse protection are specified on the rating plate.

Frost protection

Preparation

1. Empty the condensation container

2. Select any programme using the programme selector.

3. Press the

Start/ Stop button

4. Wait 5 minutes and then empty the condensation container again.

5. Turn the programme selector to Off .

Transport

– Prepare the dryer

see Frost protection.

– Transport the dryer in a vertical upright position.

– Following transportation, do not use the dryer for two hours.

The dryer contains residual water;

this can flow out if the dryer is tilted.

Take all accessory parts out

of the drum.

The drum must be empty.

Clean and level

Make sure that the air inlet

remains unobstructed

page 13.

page 10) must be the

Do not operate the dryer if

there is a danger of frost.

page 4.

condensed water is pumped into the container

Care and cleaning

Heat exchanger

The dryer's heat exchanger is cleaned automatically during drying. Cln appears in the display

panel. Do not pull out the condensation container during the cleaning process.

Dryer housing, control panel, air intake

Wipe with a soft, damp cloth.

Do not use harsh cleaning agents or solvents.

Remove detergent and cleaning agent residue immediately.

Some water may collect between the window and the seal during drying. This does not affect

the proper operation of your dryer in any way.

Filter in the condensation container

The filter is cleaned automatically when the condensation container is emptied.

However, the filter should still be cleaned regularly under running water

stubborn deposits/dirt from building up.

1. Pull out the condensation container.

2. Pull the filter out of its snap-in lock.

3. Clean the filter under running water or in the dishwasher.

4. Refit the filter.

5. Insert the condensation container so that it locks into place.

Only operate the dryer with the filter inserted.

Moisture sensor

The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how

damp the laundry is. A thin layer of limescale may build up on the moisture sensors after

prolonged use.

1. Open the door.

2. Clean the moisture sensors using a damp sponge with a rough surface.

Do not use steel wool or abrasive materials.

Appliance must be switched off.

This prevents