Bosch Programme Table Manuale di installazione e istruzioni per l'uso - Pagina 26

Water connection

Drainage into a siphon

To prevent leaks or water damage, you must observe the instructions in

this section.

If in doubt, have a technician connect the appliance.

The water supply and Drain hoses can be routed to the left of right,

depending on installation conditions.

Do not use a used inlet hose. Only use the inlet hose supplied or one

which was purchased from an authorised specialist retailer.

Do not allow the water supply hose to be:

– kinked or squashed,

– altered or cut (strength no longer guaranteed).

Note the water pressure in the mains supply:

The water pressure should be between 50-900 kPa (0.5-9 bar) (at least

8 litres of water flow out per minute when the tap is turned on).

If the water pressure is higher, a pressure reducing valve must be fitted.

Connect the cold-water supply hose (blue union nut) to the cold water tap

with ¾" pipe (3/4" = 26,4 mm) thread.

Only tighten plastic screw connections by hand.

Do not remove the filter from the supply hose.

After connecting the water supply hose:

– Turn the tap on fully.

– Check the connections for leaks.

– Do not kink the Drain hose or pull it lengthways.

– Height difference between the installation surface and the Drain:

max. 90 cm, min. 50 cm.

Secure the connection with the 24-40 mm hose clamp (included with the

appliance).