Bosch Programme Table Manuale di installazione e istruzioni per l'uso - Pagina 20

Stampa la pagina

Bosch Programme Table Manuale di installazione e istruzioni per l'uso

Water is not flowing in.

Intense vibrations during

spinning.

Washer dryer fills with water

and continuously drains it

away.

No water can be seen in the

drum.

Water leaks from the bottom

of the appliance.

Foam escapes from

detergent drawer.

Several attempts to start

spinning.

Washing is not spun

properly.

Washing results not

satisfactory.

Detergent residues on the

washing.

Grey residues on the

washing.

The mains plug is not correctly

plugged in.

The door is not properly closed.

The tap is not turned on.

The filter in the water supply hose is

blocked.

The water supply hose is pinched or

kinked.

The washer-dryer is not correctly

levelled.

The transport safety bolts have not

been removed.

Drain hose fitted too low.

Not a fault.

Supply hose screw connection is

leaking.

Drain hose is leaking.

Too much detergent has been used.

Not a fault.

The unbalanced load detection system

attempts to redistribute an unbalanced

load by starting to spin several times.

Large items of laundry are not evenly

distributed in the drum. The spin speed

is automatically reduced for safety

reasons.

Uncleaned areas worse than expected. Select a suitable programme, e.g. a

Too little or incorrect detergent used.

Maximum load exceeded.

Some phosphate-free detergents

contain water-insoluble residues which

appear on washing as light specks.

Soiling caused by ointments, grease or

oil.

Plug in the mains plug correctly.

Close the door.

Turn on the tap.

Clean the filter in the water supply hose

→ page 18.

Check the water inlet hose.

Level the washer-dryer → page 25.

Remove the transport safety bolts

→ page 24.

Fit the drain hose correctly → page 27.

During certain programmes the water

level is below the visible range.

Tighten the screw connection.

Have the drain hose replaced by the

after-sales service.

Only use detergent which is correct for

textiles, and suitable for use in

automatic washing machines.

Make sure that you use the correct

dosage.

Always wash large and small items

together.

Always wash large and small items

together.

programme with prewash. Pretreat

stains if necessary.

Use the correct dosage of a suitable

detergent, in accordance with the

manufacturer's instructions.

Select the correct load for the

programme.

Rinse the laundry again or change to

using liquid detergent. Brush the

laundry after it has dried.

Wash the laundry using the maximum

detergent dosage and the maximum

permissible temperature – see the

care label.