Community WX-1294 Manuale di installazione e funzionamento - Pagina 8
Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Altoparlanti Community WX-1294. Community WX-1294 16. Wet x premium quality all-weather/all-purpose loudspeakers
Stampa la paginaMOunT ThE lOudSpEakER (cont'd)
q Attach the provided 2" gaskets to the inside surface of
the bracket arms. With the adhesive side facing the inside
of the bracket, align with the large hole and press into place.
q Lift the loudspeaker into place between the bracket arms.
Attach the loudspeaker to the bracket using the 1/2"-13
hardware as shown in Figure 3. Repeat for the opposite
side. Tighten bolts to finger tight (enough to hold the speaker
in position).
q Determine the approximate angle of downward tilt. It
must be at least 5° down from horizontal to maintain the
Enclosure
ROTaTIng ThE hORn
While the horn orientation for the HF section of the
WET X loudspeakers is determined when the loudspeaker
is ordered, if it becomes necessary, the horn can be rotated
in the field, offering greater coverage pattern options.
Simply remove the grille and the eight (8) screws mounting
the horn. Being sure not to twist the HF wiring, rotate the
horn 90 degrees and place it evenly back into the cabinet
face. Reinstall the horn screws and the grille assembly (See
Figure 4).
IMpORTanT: When reinstalling the grill screws, tighten the
screws to finger tight and then add an additional half turn.
Over-tightening may damage or compromise the weather-
resistance of the enclosure.
Page 8
stated enclosure IP54 rating. There are degree marks on the
outside of the bracket slot to help keep the angle consistent.
Place the provided smaller rubber gasket washers between
the yoke and cabinet and install bolts as shown. Tighten to
finger tight to hold the angle. Fully tighten the hardware (so
cabinet can no longer freely rotate) to ensure that cabinet is
secure and the angle is set.
Rubber Washer
Figure 3. Attach bracket to loudspeaker
5 x 30 mm Pan Head Screws
Installation and Operation Manual
cauTIOn: Over-tightening the hardware can
damage the bolts, threaded inserts, or the cabinet
finish.
Rubber gasket (align and adhere adhesive side to bracket)
Bracket
1/2" SS Flat Washer
1/4" SS Lock Washer
1/4" SS Flat Washer
Figure 4. To rotate horn - remove screws, carefully pull
horn out, rotate 90°, place horn back in cabinet, and
replace screws.
1/2" SS Lock Washer
1/2"-13 x 2" SS Hex Bolt
1/4"-20 Hex Bolt (secures angle)
90°
WET X