Bosch Programme Table Manuale di istruzioni - Pagina 8

Stampa la pagina

Bosch Programme Table Manuale di istruzioni

What to do if ...

Water is running out.

– Correctly attach/replace drainage hose.

– Tighten screw-fitting on the supply hose.

Water not flowing in.

–

Start/Pause not selected?

Detergent not washed in.

– Tap not open?

– Filter blocked? Clean the filter.

– Supply hose kinked or jammed?

Washing-machine door

– Safety function active. Stop programme?

cannot be opened.

– Rinse Hold (without final spin) selected?

– Can be opened via emergency release only?

Programme does not start. –

Start/Pause not selected?

– Door closed?

Detergent solution is not

– Rinse Hold (without final spin) selected?

drained.

– Clean the drain pump.

– Clean outlet pipe and/or drainage hose.

Water not visible in the

– Not a fault – water below the visible area.

drum.

Spin result not satisfactory,

– Not a fault – unbalanced load detection system has stopped the spin

washing wet/too damp:

cycle, washing unevenly distributed.

Distribute small and large items of washing in the drum.

–

Reduced Ironing is selected?

– Too low speed selected?

The programme duration

– Not a fault – the programme sequence is optimised for the particular

changes during the wash

wash process. This may result in changes to the programme duration

cycle.

in the display field.

Spin cycle actuated several

– Not a fault – unbalanced load detection system adjusts imbalance.

times.

Residual water in the

– Not a fault – effect of the care product not impaired.

dispenser for care

– If required, clean insert.

product

Odour formation in the

– Run

washing machine.

Use standard detergent.

Foam is coming out of the

– Too much detergent used?

detergent drawer.

Mix 1 tablespoon of fabric softener with ½ litre of water and pour into

dispenser II (not for outdoor, sports and down-filled textiles!).

– Reduce detergent dosage for the next wash cycle.

Loud noise formation,

– Appliance feet fixed?

vibrations and "Wandering"

Secure appliance feet.

during spin cycle.

– Transportation protection devices removed?

Remove transportation protection devices.

Noises during spin

– Clean the drain pump.

and drain cycles.

Indicator lights do not

– Power failure?

function while the

– Fuse tripped? Switch on/replace fuse.

appliance is running.

– If the fault occurs repeatedly, call customer service.

The programme takes

– Not a fault – unbalanced load detection system adjusts imbalance

longer than usual.

by repeatedly distributing the washing.

– Not a fault – foam detection system active – a rinse cycle is

switched on.

Detergent residue on the

– Occasionally phosphate-free detergents contain water-insoluble

washing.

residue.

– Select

In the pause status

– Water level too high. Washing cannot be reloaded.

Start/Pause flashes very

Immediately close washing machine door.

quickly and a signal

– Select

sounds.

If a fault cannot be rectified (switching the machine on and off) or a repair is required:

– Set programme selector to Off and pull out the mains plug.

– Turn off the tap and call customer service.

Page 10

Page 4

Page 3, 4

Page 6

Page 3, 4

Page 10

Page 5

Page 9

Cottons 90 °C programme without washing.

Installation Instructions

Page 10

Rinse/Freshen Up or brush the laundry after washing.

Start/Pause to continue the programme.

Installation Instructions

Washing machine

en Instruction manual