Bosch Programme Table Manuale di istruzioni - Pagina 5

Stampa la pagina

Bosch Programme Table Manuale di istruzioni

Information on laundry ...

Labelling of fabrics

Follow the manufacturer's care information.

Drying at normal temperature.

Drying at low temperature

also select

Do not machine dry.

Observe safety instructions without fail

Do not tumble-dry the following fabrics for example:

– Impermeable fabrics (e.g. rubber-coated fabrics).

– Delicate materials (silk or curtains made from synthetic material)

– Dripping wet washing high

– Laundry contaminated with oil.

Drying tips

– To ensure a consistent result, sort the laundry by fabric type and drying programme.

– Always dry very small items (e.g. baby socks) together with large items of laundry (e.g. hand

towel).

– Close zips, hooks and eyelets, and button up covers.

Tie fabric belts, apron strings, etc. together

– Do not over-dry easy-care laundry

Allow laundry to finish drying in the air.

– Do not dry woolens in the dryer, only use to freshen them up

Programme (depending on model).

– Do not iron laundry immediately after drying, fold items up and leave for a while

remaining moisture will then be distributed evenly.

– The drying result depends on the type of water used during washing.

of the drying result

Page 6.

– Machine-knitted fabrics (e.g. T-shirts or jerseys) often shrink the first time they are dried

do not use the Extra Dry programme.

– Starched laundry is not always suitable for dryers

adversely affects the drying operation.

– Use the correct dosage of fabric softener as per the manufacturer's instructions when

washing the laundry to be dried.

– Use the timer programme for small loads

Environmental protection / Energy-saving tips

– Before drying, spin the laundry thoroughly in the washing machine

speed the shorter the drying time will be (consumes less energy), also spin easy-care

laundry.

– Put in, but do not exceed, the maximum recommended quantity of laundry

programme overview

Page 7.

– Make sure the room is well ventilated during drying.

– Clean the fluff filter after every drying cycle

– Do not obstruct or seal up the air inlet.

Low Heat.

Page 11!

they may crease.

energy consumption!

risk of creasing!

Page 7, Woollens finish

starch leaves behind a coating that

this improves the drying result.

the higher the spin

Page 4.

Fine adjustment of the drying result

Adjustment of the levels of dryness

Turn to Off

L:00, L:01, L:02, L:03 are shown in sequence

Short signal when changing from L:03 to L:00,

otherwise long signal.

Care and cleaning

Dryer housing, Control panel, Air inlet, Moisture sensors

– Wipe off with a soft, damp cloth.

– Do not use abrasive cleaners or solvents.

– Remove detergent and cleaning agent residue immediately.

the

Exhaust air duct

Fine adjustment

Check the exhaust air duct. Clean the exhaust air duct every six months.

Do not bend the exhaust air duct.

1. Switch off the dryer and allow it to cool down.

2. Disconnect the mains plug.

3. Remove the exhaust air duct.

4. Clean the exhaust air duct.

5. Refit the exhaust air duct

Moisture sensors

The dryer is equipped with stainless steel moisture sensors.

Moisture sensors measure the moisture level of the laundry.

After sustained, repeated operation, a fine layer of limescale may form

on the moisture sensors.

1. Open the door.

2. Clean the moisture sensors using a slightly damp sponge with a rough

surface.

Do not use steel wool or abrasive materials.

Low Heat and

1 x to

Press and hold

Press

turn 5 x to the right

the required level is reached

the right

Only when switched off!

Installation instructions for exhaust air duct.

Low Heat until

Turn to Off