CARNIVORE MM-12 Manuale di istruzioni - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per Elettrodomestici da cucina CARNIVORE MM-12. CARNIVORE MM-12 10. Electric meat mincer (240v) 180kg per hour mincing capacity

Stampa la pagina

Page 8

5.1 CONTROLS

1 - Start Switch "on"

2 - Stop Switch "off"

3 - Reverse Switch "turn over"

5.2 SETTING UP THE MM-12/MM-22 FOR USE

N.B before using the appliance makes sure all the components that can be removed are secured in

position (see fig 6)



Make sure all components are properly cleaned & sanitized prior to use if not refer to section 6.2

of this manual for correct cleaning instructions.



Mount the mincer block and lock it into position using the handle located on the side of the union



Mount the screw feeder, blade and disk, and then screw on the lock nut ensuring the lock nut is

only just tight, overtightening will cause excessive wear to the blade & disk.



The correct disk selection will depend on the type of meat or coarseness of the grind you require.



Ensure the food tray is fitted & pestle is inserted into the chute



Now connect the machine to the power supply & in order to prevent serious harm it is highly

recommended the mincer is plugged into an appropriate size electrical circuit that has an RCD

(Residual Current Device) also known as an RCCB (Residual Current Circuit Breaker) to quickly

disconnect the machine in the event of an ongoing electrical fault.



The machine is now ready to use.

5.3 USING THE MINCER

When using the mincer it is important that you stand in the correct position. Do not position yourself

so that any part of your body comes in direct contact with the mincer when working.

N.B The mincer must only be fed when working. The

procedure to follow is:

1. Place the food in the tray;

2. Start the mincer using the start switch & start button.

The meat should be cut beforehand into suitable size

chunks to be easily feed into the chute to avoid problems with

the screw feeder jamming.

4. Raise the pestle, feed the meat into the tube without forcing to use the pestle to push the meat into

the chute. However, if there is a problem, first try to reverse the direction of the screw feeder using the

www.machineryhouse.com.au

Instructions Manual for MM-12 (F330)

5 USING THE APPLIANCE

4 - Stop Button (red)

5 – Start Button (green)

[Type here]

www.machineryhouse.co.nz

10/06/2016