Dreamline ENIGMA-Z SHDR-62487610 Series Manuale di istruzioni per l'installazione - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Prodotto idraulico Dreamline ENIGMA-Z SHDR-62487610 Series. Dreamline ENIGMA-Z SHDR-62487610 Series 20. Shower door & tub door

Stampa la pagina

Attach the Upper guide rail (#03) to the Stationary glass (#02)

with the Glass brackets (#07) and tighten the bolts into the

pre-drilled holes in the Upper guide Rail (#03). Make sure both

adjustment disks are installed in the same direction with the high spot

towards the door end (see *NOTE below). Make sure the guide rail is

parallel with the top edge of the glass (see Fig. 4).

(EQ=Equal distance)

Slide the Door stoppers (#01) onto each end of the Upper guide rail

(#03) and secure them temporarily using the 4mm hex wrench (#11).

Slide the Guide Rail brackets (#08) onto each end of the Upper

guide rail (#03) and temporarily secure them as well. Next, assemble

the Wall Bracket (#19) onto the bottom corner of the Stationary

glass (#02) as shown in Fig. 3.5. Use the provided gaskets to protect

the glass.

glass bracket

adjustment

disk

*NOTE:

The outer glass bracket disk has an eccentric bushing

for adjustment. Be sure to install both glass bracket disks with

the high spot of the bushing pointed towards the door end of

the guide rail. See the detail of the disks below as viewed from

inside prior to installing on the glass.

High spot of disk bushing

ENIGMA-Z manual Ver 1 Rev 4 10/2016

See Fig. 3 and Fig. 4 for details

after adjusting the

disk, use this hole to

hold it in place with

a small allen wrench

Door end of guide rail

outside

Fig. 3

measure

Fig. 4