Carolina Extreme Duty XBC-8 Manuale del proprietario/operatore - Pagina 15
Sfoglia online o scarica il pdf Manuale del proprietario/operatore per Decespugliatore Carolina Extreme Duty XBC-8. Carolina Extreme Duty XBC-8 16.
Stampa la pagina
Troubleshooting
Problem
Cutter bogs down
Vibration felt when
running cutter
Blades get dull too quickly
Blades breaking
Hydraulic oil level goes
down during operation
Blades do not spin when
flow is activated
Carolina Attachments LLC.
Cause
Deck is not properly
leveled & material is
balling under deck
Dull blades
Ground speed too fast
Cutter speed too slow
Missing, loose, damaged or
unbalanced cutter blades
Blade mount damaged
Planetary set loose on deck
Cutting height too low for
cutting in sandy or rocky
soils
Blades have contacted
solid objects (rocks, steel
pipes, etc.)
Exessive shock loads
Leak at cutter motor or
other plumbing
Leaks in skid steer
hydraulic system
Motor seal leak
No oil flow
Motor or drive shaft failed
Page 15
Resolution
Refer to leveling
instructions found in this
manual.
Remove and sharpen
blades.
Slow down ground speed.
Raise engine RPMs or
investigate other low oil
flow problem
Replace blades with new or
re-sharpened and equally
balanced blades.
Replace blade mount
Tighten & torque
mounting bolts. Replace
bolts if they are damaged.
Raise cutter height.
Clear cutting area of solid
objects before hitting
them, or raise the cutter
height to clear exposed
rock surfaces.
Avoid hitting solid objects
(rock, steel pipes, large
tree stumps, etc.).
Investigate & repair
Investigate & repair
Cutter run without case
drain connected to skid
steer.
Confirm that quick
disconnects are fully
seated in their mating
connector.
Check that skid steer
auxiliary circuit is
activating.
Call your dealer for further
recommendations.
Extreme Brush Cutters
September 2018