Bosch WTY88898SN Manuale di installazione e istruzioni per l'uso - Pagina 36
Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Asciugatrice Bosch WTY88898SN. Bosch WTY88898SN 40.
Anche per Bosch WTY88898SN: Manuale di installazione e istruzioni per l'uso (36 pagine)
Stampa la pagina
Faults and what to do about them
en
Faults
Laundry is not dried cor-
rectly or is still too damp.
Drying time too long?
Display panel goes off
and Start button flashes.
Residual water in
the condensate con-
tainer despite the dryer
being connected to
the condensation drain*.
Humidity in the room
increases.
Power cut.
Unusual noises when
drying.
The dryer feels cold
despite drying.
* Depending on the model
If you cannot rectify the fault yourself by turning the dryer off and on, please
Note:
contact our after-sales service.
36
Cause/remedy
After the end of the programme, warm laundry feels damper than it actually
■
is. Spread the laundry out and allow the heat to disperse.
Finely adjust the dryness level – this extends the drying time but does not
■
increase the temperature. Your laundry will become drier ~ Page 26.
Select a programme with a longer drying time or increase the drying level.
■
This does not increase the temperature.
Select a timed programme for subsequent drying of laundry that is still
■
damp ~ Page 25.
If you have exceeded the maximum load for the programme, the laundry
■
may not be dried properly.
Clean the moisture sensor in the drum. The sensor may become covered by
■
a fine layer of limescale or residues of detergents and care products which
then impair its function. Your laundry is not being dried correctly
~ Page 33.
Drying has been interrupted as a result of a power cut, because the conden-
■
sate container is full or because the maximum drying time has been
exceeded.
See also the laundry tips ~ Page 24.
Note:
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
■
ter.
If the air inlet on the dryer is blocked or not freely accessible, this may
■
increase the drying time. Make sure that the air inlet remains unobstructed.
The optimum ambient temperature for drying is between 15 °C and 30 °C.
■
Outside of this range, the drying time may increase.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Not a fault. Energy saving mode is active ~ Page 12.
Not a fault. If the condensation drain is installed, residual water remains in
the condensate container due to the dryer's self-cleaning function.
Not a fault. Make sure the room is sufficiently ventilated.
The drying programme is interrupted. Remove the laundry and spread it out,
or restart the programme.
Not a fault. Noises are produced by the automatic cleaning of the heat
exchanger ~ Page 32.
Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.