Andis BDC Manuale di istruzioni per l'uso e la cura - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso e la cura per Tagliacapelli Andis BDC. Andis BDC 12.

REPLACING OR CHANGING BLADE SET

To replace or change your blade set, slide the blade bracket onto the hinge of

the clipper (Figure E) and with the clipper turned ON, push the blade towards

the clipper to lock into position.

USER MAINTENANCE

The internal mechanism of your motor clipper has been permanently lubricated

by the factory. Other than the recommended maintenance described in this

manual, no other maintenance should be performed, except by Andis Company,

or an Andis authorized service station. To find an Andis authorized service

station near you log on to www.andis.com or contact our customer service

department at 1-800-558-9441.

BLADE TEMPERATURE

Due to the high speed nature of Andis clippers, please check for blade heat

often, especially on close cutting blades. If blades are too hot, dip the blades

only into Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis

Clipper Oil. With this detachable blade unit, you can change your blade in order

to maintain a comfortable temperature; using multiple blades of the same size is

popular among groomers.

CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES

Blades should be oiled before, during, and after each use. If your clipper blades

leave streaks or slow down, it's a sure sign blades need oil. Place a few drops of

Andis Clipper Oil on the front and side of the cutter blades (Figure F). Wipe

excess oil off blades with a soft dry cloth. Spray lubricants contain insufficient oil

for good lubrication, but are an excellent clipper blade coolant. Always replace

broken or nicked blades to prevent injury. You can clean the excess hair from

your blades by using a small brush or worn out tooth brush. To clean the blades

we suggest to immerse the blades only into a shallow pan of Andis Blade Care

Plus, while the clipper is running. Any excess hair and dirt that has accumulated

between the blades should come out. After cleaning, turn your clipper OFF and

dry blades with a soft, dry cloth and start clipping again.

If upon cleaning your blades you find that the blades will still not cut, there may

be a few fine pieces of hair trapped between the upper and lower blade. If this

happens, you will need to snap the blade off the clipper. Proceed to slide the

upper blade to one side, without loosening the tension spring or moving the

upper blade completely out from under the tension spring (See Figure G for

position of blade). Wipe the surface between the blades clean with a dry cloth,

then place a drop of clipper oil where the upper and lower blades meet and also

in the guide slot of the tension spring (Figure G). Now slide the upper blade to

the opposite side of the lower blade and repeat this process. After completing

this procedure, slide the upper blade, centering it over the lower blade. Handle

or store your Andis Clipper with the blades down so excess oil will not run into

the clipper case.

OIL

CORRECT

INCORRECT