Comnet CWFE2SCM2 Manuale di installazione e funzionamento - Pagina 6
Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Convertitore multimediale Comnet CWFE2SCM2. Comnet CWFE2SCM2 10. Commercial grade 10/100 mbps ethernet 2 port electrical-to-optical media converter
Anche per Comnet CWFE2SCM2: Manuale di installazione e funzionamento (12 pagine), Manuale di avvio rapido (4 pagine)
Stampa la pagina
INSTRUCTION MANUAL
DIP-switch
The DIP-switch is used to configure operation mode for LLF (Link Lost Forwarding) and operation
mode for UTP/Fiber port. The default value of DIP switch is OFF.
Link Lost Forwarding (DIP-Switch 3): When LLF is enabled, it allows UTP link failures to be reported
to the fiber side and also allows a fiber link failure to be reported to the UTP side. Therefore, a link
loss forward feature is provided in both UTP and fiber side.
Pure Converter mode (DIP-Switch 4): When the pure converter mode is enabled (on), it operates
with minimal latency. The transmission flow does not wait until the entire frame is ready, but
instead it forwards the received data immediately after the data has been received. The UTP port
should be forced at 100M in this application. When DIP-Switch is in Switch Converter mode (off),
the converter function is same as Switch Hub.
Note: Do not change the DIP-switch setting when UTP or fiber port is transmitting or receiving
data. It may cause some data errors. If you change the DIP-switch setting, please power off
the converter and power it on again to make the setting effective.
TECH SUPPORT: 1.888.678.9427
SW No
Status
Description
1
ON
UTP 100 Mbps Full Duplex Mode
OFF
UTP Auto-Negotiate
2
ON
Fiber in Half Duplex
OFF
Fiber in Full Duplex
3
ON
LLF Enable
OFF
LLF Disable
4
ON
Pure Converter mode
OFF
Switch Converter mode
CWFE2SC(M,S)2
QSG_CWFE2SC(M,S)2 Rev. 11.17.17 PAGE 6