Carp Royal EARL Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzatura da pesca Carp Royal EARL. Carp Royal EARL 13. Remote controlled bait boat

Stampa la pagina

Trouble Shooting

No.

Fault Phenomena

The transmitter buzzes intermittently

when it is powered on.

The boat gives no response

when all powers are ON and

full.

The R.C. gives no response and the

LED on the receiver is in RED when

all powers are ON and Full.

Motor runs by itself when all powers

are ON and full and in right order,

yet the transmitter is not operated.

Motor doesn't work or stops by

accident when all powers are ON

and full.

（Shoot troubles one by one）

To ensure a normal use of our product, we suggest you settle some simple faults according to directions of this manual.

For faults that you can not settle by yourself, please contact Carp Royal in time and with full data required.

Possible Causes

Batteries are in low power.

Batteries in the transmitter are set

up in the wrong way.

R.C. fault.

Signal interferences occurred, or

the signal of transmitter and

receiver is not matched.

Code Matching is needed.

Same as No. 3.

R.C. fault.

Signal interferences occur.

Fuse burns out.

Wires in the boat are connected

poorly.

Receiver fault.

Transmitter fault.

Speed Controller fault.

Motor fault.

Trouble Shooting

Change to new batteries.

Check batteries.

Check R.C. & if need return the whole set of R.C. (incl.

transmitter and receiver) to CarpRoyal.

1. Receiver: turn ON the Main Switch on the boat, press

and hold the Set Key on the receiver till the LED

Indicator turns from red to flickering orange. Then,

release the key.

2. Transmitter: press and hold the Code Matching Key

and turn ON the Main Switch at the same time, you can

see the LED Monitor in green. Release and press again

the Code Matching Key, and the LED Monitor turns from

green to orange. Then press and hold the Code Matching

Key till the LED Monitor turns to flickering orange, then

check both LED Monitors. If the LED Monitor on the

Receiver is OFF and the one on the transmitter is in

green, code matching is finished successfully and you can

release the key.

3. Turn OFF the Main Switch of the boat and transmitter at

first and turn ON them again to check the R.C is all right

or not.

4. Please make sure Code Matching is set in short distance

and no signal interference or other Code Matching exist.

Same as No.3.

Return the whole set of R.C. (incl. transmitter and

receiver) to Carp Royal.

Check if there are any strong signals interferences occur,

such as communication facilities, power lines or

skyscrapers.

Change new fuse.

Attention: ONLY 10 or 15 A fuses can be used.

Check and re-connect.

Open the Window Cover, and check if the receiver is well

connected:

1. Numbers on the wires are corresponding to numbers on

the receiver.

2. The metal side of plugs should all face the smaller

number on the Receiver when connecting.

3. Exchange the new receiver and do Code Matching, and

check again.

4. After above 3 steps checking and not solve problem,

please return the whole set of R.C. (incl. transmitter and

receiver) to Carp Royal.

Return the whole set of R.C. (incl. transmitter and

receiver) to Carp Royal.

Exchange the speed controller and return the fault one to

Carp Royal.

Change new motor in this way:

1. Take off the propeller and disconnect the motor.

2. Take off screws on the Motor Base, and gently pull out

the full set of motor.

3. Set up a set of new motor.