Electrolux EHDP8740IK Manuale - Pagina 15

Sfoglia online o scarica il pdf Manuale per Piano cottura Electrolux EHDP8740IK. Electrolux EHDP8740IK 20.

Stampa la pagina
Problem
comes on.
comes on.
comes on.
comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also three
digit letter code for the glass ceramic (it is
in the corner of the glass surface) and an

8. INSTALLATION

WARNING!
Refer to Safety chapters.
8.1 Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
Possible cause
The electrical connection is
incorrect. The supply volt-
age is out of range.
There is an error in the hob
because a cookware boils
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.
The cooling fan is blocked.
The electrical connection is
incorrect. The hob is con-
nected only to one phase.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.
8.3 Connection cable
• For a single phase or two phase
connection use the following (or higher)
ENGLISH
Remedy
Speak to a qualified electri-
cian to check the installa-
tion.
Deactivate the hob. Re-
move the hot cookware. Af-
ter approximately 30 sec-
onds, activate the zone
again. If the cookware was
the problem, the error mes-
sage goes out. Residual
heat indicator can stay on.
Let the cookware become
sufficiently cool. Check if
your cookware is compati-
ble with the hob.
Refer to "Hints and tips"
chapter.
Check if objects block the
cooling fan. If
comes
on again, speak to an Au-
thorised Service Centre.
Speak to a qualified electri-
cian to check the installa-
tion. Refer to the connec-
tion diagram.
15