Bosch GSB 12 VE-2 Manuale di istruzioni per l'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Trapano Bosch GSB 12 VE-2. Bosch GSB 12 VE-2 10. Professional
Anche per Bosch GSB 12 VE-2: Manuale di istruzioni per l'uso (10 pagine), Manuale di istruzioni per l'uso (10 pagine)
Stampa la pagina
Battery and Battery Charger
The enclosed operating instructions for the
battery charger must be read carefully!
Recharge only with the charger specified
by the manufacturer. A charger that is suita-
ble for one type of battery pack may create a
risk of fire when used with another battery
pack.
Allow a heated battery to cool before charging.
Protect the battery from heat and fire: Danger
of explosion! Do not place the battery on radi-
ators or expose to strong sun rays for a longer
time; temperatures over 50 °C cause damage.
Do not open the battery, and protect it from im-
pact. Store in a dry and frost-free place.
When battery pack is not in use, keep it
away from other metal objects like paper
clips, coins, keys, nails, screws, or other
small metal objects that can make a con-
nection from one terminal to another.
Shorting the battery terminals together may
cause burns or a fire.
Do not dispose of the battery in household
waste or discard into fire or water.
Before Putting into Operation
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approximately 5 charging/discharging
cycles.
To remove the battery 6, press the unlocking but-
tons 8 and pull out the battery downwards. Do not
exert any force.
The battery is equipped with an NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C.
A long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the batteries are used and
must be replaced.
Observe the notes on environmental protec-
tion.
14 • 2 609 932 156 • TMS • 10.09.02
Auxiliary Handle (see figure
(GSB 12 – 24 VE-2/
GSR 18 – 24 VE-2)
Loosen the handle by turning to the left. Rotate
the auxiliary handle 9 and adapt to the working
position. Make sure that the clamping band 11 of
the auxiliary handle remains in the groove.
Afterwards tighten the handle again by turn-
ing in clockwise direction.
Changing the Tool
Open the drill chuck until the tool can be inserted.
Insert the tool.
Firmly tighten the sleeve of the keyless chuck 3
by hand until the locking action ("click") is no
longer heard. This automatically locks the chuck.
Rotate the sleeve in the reverse direction to re-
move the tool.
Screwdriving (see figure
Clamp the bit 12 directly into the drill chuck. For
quick changes, using the universal bit holder 7 is
recommended.
Initial Operation
Inserting the Battery
Set the rotational direction switch 5 to the centre
position = lock-off and allow the charged bat-
tery 6 to engage into the handle.
Switching On and Off
To start the machine, press the On/Off switch 4
and keep it depressed.
To switch off the machine, release the On/Off
switch 4.
English - 3
B
The machine runs with variable
speed between 0 and maximum,
depending on the pressure applied
to the On/Off switch 4. Light pres-
sure results in a low rotational
speed thus allowing smooth, con-
trolled starts. Do not strain the ma-
chine so heavily that it comes to a
standstill.
)
A
)