AirTech Air+ PIV Istruzioni per l'installazione e la messa in funzione - Pagina 5
Sfoglia online o scarica il pdf Istruzioni per l'installazione e la messa in funzione per Ventilatore AirTech Air+ PIV. AirTech Air+ PIV 16. Positive input ventilation unit
Anche per AirTech Air+ PIV: Istruzioni per l'installazione e la messa in funzione (16 pagine)
Stampa la pagina
Hanging method:
The Air+ PIV can be hung from a roof beam (Fig. 2).
roof beam.
Use the cord provided to loop through the eye and around the handle on the
unit, there are various notches for the cord to run through, tie the two ends together
using a suitable knot such as an over hand or fisherman's knot.
Ensure that the route for the flexible ducting has gentle bends and that the duct
cannot be crushed. See Diffuser Grille Fitment section below for more information.
Fit the filters to the unit.
This will ensure that all the fresh air entering the dwelling has passed through the
filter first.
Ensure that the screw eye is attached to the beam strongly enough and that the beam is
in sufficient condition to withstand the load.
Floor mounting:
Find a suitable location to fix the unit near to where the diffuser is to be located.
Ensure that the route for the flexible ducting has gentle bends and that the duct
cannot be crushed.
Affix the mounting base to a wooden board or two lengths of timber which can then be
screwed to the joists.
Place the unit in the mounting base cradle; two retaining pins hold the unit in place.
Fit the filters to the unit.
This will ensure that all the fresh air entering the dwelling has passed through the
filter first.
Please make sure that the filter is fitted correctly.
(USING ACCESSORY MOUNTING BASE – 477749 – Not supplied)
Please make sure that the filter is fitted correctly.
Fig. 3.
Fix the screw eye to a convenient
The unit weight is approximately 4 kg.
Fig.2.
Filters
5
Fig. 4.