1Wing XBow2 Istruzioni per la costruzione - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per la costruzione per Giocattolo 1Wing XBow2. 1Wing XBow2 10.

Stampa la pagina
General information – tips&tricks
The build instructions are setup in a way that the XBow may be build in two evening sessions and
curing happens overnight. Final steps may be completed on the third day.
•
Especially with flying wings, accurate CG and slop-free linkages are absolutely critical to
achieve best performance and handling. Please use the described cross-linkages and no
RDS/IDS systems.
•
Following the overall concept of an extremely robust model, it is not recommended to install
8mm wing servos. Slop or broken gears during hard landings is just a matter of time.
•
KST X10mini in servo frames with counter bearing are highly recommended.
•
The recommended antenna position, behind the wing has proven to be very reliable. Any
other antenna installation may induce risk of control link issues.
•
During build, please make sure to put the wing on a soft surface to avoid scratches.
•
Please put tape around all areas where you are working on to avoid damage to the surfaces.
•
We highly recommend 24h gluing epoxy (Uhu Endfest, Araldite, etc.). Thickening (e.g. with
Thixo) may help with proper installation of the control horns.
•
Any glue remains on carbon surfaces should be removed immediately e.g. with Q-tips and
Alcohol (Isopropanol). Acetone may render the clear carbon surfaces matte.
•
There are very different clear tape qualities. We highly recommend "Tesa Kristall"
•
Magnetic switches (e.g. Zepsus Nano) make your life easier.
•
Clear carbon surfaces heat up significantly in direct sunlight. Installed electronics and battery
cells may get damaged. Please protect your model when not in use.
•
Flying wings without fuselage should be best launched with a little unconventional grip.
Thumb on top, four fingers below the wing. Please see the video:
https://youtu.be/J36w8RoruNk
Content of this kit
1. Wing
2. Tail
3. Carbon tubes for tail boom interface:
1x 10x9x8mm
1x 9x8x38mm
1x 8x6x38mm
4. Tail boom (1 spare)
2x 10x9x100mm
5. 2x carbon control horns
6. Carbon bungee hook
7. 3x 60g self-adhesive weight
8. Carbon sheet material for hatches
1Wing
Martin Stobbe
Am Kuchelberg 2
82266 Inning am Ammersee
www.onewing.de