Electrolux EFC 009.1X Manuale d'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso per Cappa di ventilazione Electrolux EFC 009.1X. Electrolux EFC 009.1X 14. Electrolux cooker hood

Stampa la pagina

Safety warnings

For kitchen unit installer

Attention: The air outlet must not be connected

to chimney flues or combustion gas ducts. The

air outlet must under no circumstances be

connected to ventilation ducts for rooms in

which fuel-burning appliances are installed.

• When used as an extractor unit, the hood

must be fitted with a 150mm diameter hose.

• When installing the hood, make sure you

respect the following minimum distance

from the top edge of the cooking hob/ring

surfaces:

electric cookers

gas cookers

coal and oil cookers

• If the cooker hood is operating in the suction

version concurrently to other combustion

appliances you will need to ensure that the

depression in the environment of these instal-

lations does not exceed the 4PA (4x10

• The air outlet must not be connected to

chimney flues or combustion gas ducts. The

air outlet must under no circumstances be

connected to ventilation ducts for rooms in

which fuel-burning appliances are installed.

• It is advisable to apply for authorization from

the relevant controlling authority when

connecting the outlet to an unused chimney

flue or combustion gas duct.

The air outlet installation must comply with

the regulations laid down by the relevant

authorities.

• When the unit is used in its extractor version,

a sufficiently large ventilation hole must be

provided, with dimensions that are approxi-

mately the same as the outlet hole.

• National and regional building regulations

impose a number of restrictions on using

hoods and fuel-burning appliances connected

to a chimney, such as coal or oil room-

heaters and gas fires, in the same room.

• Since the rule for rooms with fuel burning

appliances is "outlet hole of the same size as

the ventilation hole", a hole of 500-600 cm

which is to say a larger hole, could reduce

the performance of the extractor hood.

600 mm

750 mm

850 mm min.

-5

bar).

• If the hood is used in its filtering function, it

will operate simply and safely in the above

conditions without the need for any of the

aforementioned measures.

• When the hood is used in its extractor func-

tion, the following rules must be followed to

obtain optimal operation:

— short and straight outlet hose

— keep bends in outlet hose to a minimum

— never install the hoses with an acute

angle, they must always follow a gentle

curve only

— keep the hose as large as possible (prefer-

ably the same diameter as the outlet hole).

• Failure to observe these basic rules will

drastically reduce the performance and

increase the noise levels of the extractor

hood.

For user

• Always cover lighted elements, to prevent

excess heat from damaging the appliance. In

the case of oil, gas and coal fired cookers it is

essential to avoid open flames.

• Also, when frying, keep the deep frying pan

on the cooker top/cooker under careful

control.

• The hot oil in the frying pan might ignite due

to overheating.

• The risk of self-ignition increases when the

oil being used is dirty.

• It is extremely important to note that over-

heating can cause a fire.

• Never carry out any flambé cooking under

the hood.

• Always disconnect the unit from the power

supply before carrying out any work on the

hood, including replacing the light bulb

(take the cartridge fuse out of the fuse holder

or switch off the automatic circuit breaker).

• It is very important to clean the hood and

replace the filter at the recommended

intervals. Failure to do so could cause

grease deposits to build up, causing a fire

hazard.