Electrolux EFC 6420 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Cappa di ventilazione Electrolux EFC 6420. Electrolux EFC 6420 15. Electrolux cooker hood
Anche per Electrolux EFC 6420: Manuale d'uso (15 pagine), Manuale d'uso (15 pagine), Manuale d'uso (15 pagine)

Stampa la pagina

Charcoal filter

• The charcoal filter should only be used if you

want to use the hood in the recirculation

function.

• To do this you will need an original

ELECTROLUX charcoal filter (available from

your local Service Force Centre).

• Cleaning/replacing the carbon filter

Unlike other carbon filters, the LONGLIFE

carbon filter can be cleaned and reactivated. At

normal use the filter should be cleaned every

second month (when using the hood 2,5 hours

per day, in avarage). The best way to clean the

filter is in the dishwasher. Use normal detergent

and choose the highest temperature (65º C).

Wash the filter separately so that no food parts

gets stuck on the filter and later causes bad

odours. To reactivate the carbon, the filter

should be dried in an oven for 10 minutes with a

temperature of maximum 100º C.

After approximately three years of use, the

carbon filter should be replaced with a new, as

the odour reduction capacity will be reduced.

• Fitting

Remove the frame i which supports the filter h

by turning 90° the two knobs g.

Insert the charcoal filter inside the frame and

put all parts back in their place. Fig. 5.

• To remove proceed in the reverse order.

• Always specify the hood model code number

and serial number when ordering replacement

filters. This information is shown on the

registration plate located on the inside of the

unit.

• The charcoal filter can be ordered from your

local ELECTROLUX Service Force Centre.

Changing the light bulb - Fig. 6

• Disconnect the cooker hood from the main

supply.

• Remove the lamp cover, use a screw driver as a

lever.

• Replace the old bulb with a new one of the

same type.

• Refit the lamp cover.

• If the light does not come on, make sure the

bulb has been inserted correctly before

contacting your local Service Force Centre.

Fig. 5

Fig. 6