Electrolux RH30WC55GS Manuale di installazione, uso e cura - Pagina 10

Sfoglia online o scarica il pdf Manuale di installazione, uso e cura per Cappa di ventilazione Electrolux RH30WC55GS. Electrolux RH30WC55GS 21. 30” et 36” hotte aspirante
Anche per Electrolux RH30WC55GS: Catalogo ricambi di fabbrica (4 pagine), Opuscolo e specifiche (2 pagine), Manuale di installazione, uso e cura (20 pagine), Manuale di installazione, uso e cura (20 pagine), Manuale di installazione, uso e cura (20 pagine), (Inglese) Guida all'installazione, all'uso e alla cura (25 pagine), (Francese) Manuale di installazione, uso e manutenzione (21 pagine)

Installing the hood

Install framing for hood support

If drywall is present, mark the screw hole

locations. Remove the template.

Cut away enough drywall to expose 2 vertical

studs at the holes location indicated by the

template.

Install two horizontal supports at least 1"x 6"

between two wall studs at the bottom and top

mounting holes installation location.

room side of the studs.

Use cleats behind both sides of the support to

secure to wall studs.

IMPORTANT:

Framing must be capable of supporting 100 lbs.

Install the 8" round transition as shows the image below.

The installation screws and the 8" round transition are

included on the hood package.

2 people are required to lift and position the hood

onto the mounting screws.

Place the template on the wall along the horizon-

tal line, make sure the template is leveled and

centered with the centerline.

Mark "upper" screw holes locations in the wall.

IMPORTANT. Check to be sure that hole locations

are leveled and correctly centered by the vertical

centerline.

Drive "upper" wood screws by hand. Leave ¼ " of

distance between the screw head and the wall.

onto the "upper" screws.

Mark "lower" wood

screw holes locations

in the wall using a

pencil.