Electrolux U24211 EFT 530 Istruzioni per l'uso e l'installazione - Pagina 7
Sfoglia online o scarica il pdf Istruzioni per l'uso e l'installazione per Cappa di ventilazione Electrolux U24211 EFT 530. Electrolux U24211 EFT 530 15. Electrolux range hood operation and installation manual
Stampa la pagina
Paper grease filter (EFT 630-530)
• The purpose of the grease filters is to absorb
grease particles which form during cooking and
it must always be used, either in the external
evacuation or internal recycling function.
The paper grease filter is very thin (approx. 1
mm) and positioned on the inside of its related
support grille.
The filter should be changed once a month.
• The grille should be cleaned with luke warm
water and non-abrasive detergent when you
change the filter.
• The grease filter can be ordered from your local
Electrolux Service Force Centre.
• Opening the grille
Open the latch and swing the grille downwards.
To remove the grille, pull it forwards from the
right and release it.
Removing the filter
Open the grille and remove the stops to take
out the filter.
Charcoal filter
• The charcoal filter should only be used if you
want to use the hood in the recirculation
function.
• To do this you will need an original Electrolux
charcoal filter (available from your local
Service Force Centre).
• The charcoal filter cannot be washed nor
regenerated.
The charcoal filter should be replaced every 12
months under normal use.
Replacement filters are available from your
local Service Force Centre.
Fitting
Remove the cover by rotating the knobs to 90°,
put the charcoal filter inside and fix it by
rotating the knob to 90° then close the cover.
• To remove proceed in the reverse order.
• Always specify the hood model code number
and serial number when ordering replacement
filters. This information is shown on the
registration plate located on the inside of the
unit.
• The charcoal filter can be ordered from your
local Electrolux Service Force Centre.
Changing the light bulb
• Disconnect the cooker hood from the mains
supply.
• Remove the grid or the metal grease filter.
• Replace the old bulb with a new one of the
same type.
• Remount the grid or the metal grease filter.
• If the light does not come on, make sure the
bulb has been inserted correctly before
contacting your local Service Force Centre.
Latch
Grille
Fig. 5 - Paper Grease filter
Knobs
Knobs
Move the lever
to position F
Fig. 6 - Charcoal Filter - Fitting
36
Latch
Grease
filter
Stops
knob
Cover
Charcoal filter