Bosch 2 Manuale di istruzioni per l'uso - Pagina 15

Stampa la pagina

Washing the dishes

A qua sensor *

A q u a s e n s o r

* depending on model

The Aqua sensor is an optical measuring

device (light barrier) which measures the

turbidity of the rinsing water.

The Aqua sensor is used according to the

programme. If the Aqua sensor is active,

"clean" rinsing water can be transferred to

the next rinse bath and water consumption

can be reduced by 3–6 litres. If the

turbidity is greater, the water is drained

and is replaced with fresh water. In the

automatic programmes the temperature

and running time can also be adjusted to

the degree of soiling.

Switching on the appliance

– Turn on the tap fully.

– Switch on ON/OFF switch (.

The display of the last selected

programme flashes. This programme

remains selected unless another

programme is selected with the button

< H or button > P.

– Press the START button h.

– Close the door.

The programme starts running.

T imer programming *

T i m e r p r o g r a m m i n g

* depending on model

You can delay the start of the programme

by 3, 6 or 9 hours.

– Switch on ON/OFF switch (.

– Keep pressing the Preselected starting

time button 0 until the appropriate

display 3h, 6h or 9h is lit.

– Press START button h, timer

programming is activated.

– To delete the preselected starting time,

keep pressing the Preselected starting

time button 0 until none of the

displays 3h, 6h or 9h is lit.

You can change your programme

selection at any time until the

programme starts.

End of programme

The programme has ended when neither

of the two displays ` or X is lit.

The end of the programme is also

indicated by an acoustic signal.

The buzzer volume can be set in 4 stages.

Accordingly 0, 1, 2 or 3 displays are lit

(see Setting amount of rinse aid). Factory

setting: 2. This function can be changed

as follows:

– Open the door.

– Switch on ON/OFF switch (.

– Keep pressing button > P until

the setting light )* and "Check water

supply" )2 flash.

– Release buttons.

– Keep pressing button > P until

the setting light )* and rinse aid refill

indicator )" flash.

– Release buttons.

The refill indicators )* and )" flash

and the displays # and + are lit

(= Setting 2). The set buzzer volume

can be heard.

To change the setting:

– Press the button < H until

the required setting has been selected.

– Press START button h.

The displays go out. The selected

setting is saved.

– Close the door.

Note

To save energy, the dishwasher

automatically switches off after the end

of the programme.

aus