Bosch 8 Series Manuale di istruzioni per l'installazione e l'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione e l'uso per Aspirapolvere Bosch 8 Series. Bosch 8 Series 20. Combi steam oven
Anche per Bosch 8 Series: Manuale di istruzioni per l'installazione (21 pagine), Istruzioni per il montaggio (4 pagine), Manuale di istruzioni per l'installazione e l'uso (16 pagine), Manuale di riferimento rapido (2 pagine), Manuale d'uso e istruzioni per l'installazione (44 pagine), Come iniziare (7 pagine), Manuale di istruzioni (32 pagine), Manuale d'uso e istruzioni per l'installazione (32 pagine), Manuale di istruzioni (12 pagine), Manuale d'uso e istruzioni per l'installazione (24 pagine), Manuale d'uso (28 pagine), Manuale d'uso e istruzioni per l'installazione (28 pagine), Manuale d'uso e istruzioni per l'installazione (44 pagine), Manuale di istruzioni (12 pagine), Manuale d'uso e istruzioni per l'installazione (40 pagine), Manuale d'uso e istruzioni per l'installazione (32 pagine), Informazioni per l'uso (20 pagine), Manuale di istruzioni (48 pagine)

Bosch 8 Series Manuale di istruzioni per l'installazione e l'uso
Cleaning and maintenance
en
Saturation display
When the metal grease filters or the activated charcoal
filter are/is saturated, an audible signal sounds for
approximately four seconds after the fan is switched off.
The indicator above the corresponding symbol flashes
as well:
E
Metal grease filter:
Activated charcoal filter:
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
changed.
For instructions on how to clean the metal grease filters,
please refer to the section:
The saturation indicators can be reset while they are
flashing. To do this, touch the appropriate symbol.
Switching over the indicator for air recirculation
mode
For air recirculation mode, the electronic control
indicator must be switched over accordingly:
The extractor hood must be connected but remain
switched off.
If the air recirculation mode starter set is fitted, touch
and hold the
and
#
until the bars above symbols 1 and
CleanAir air recirculation module is fitted, touch and
hold this button combination again until the bars
above 2 and
light up.
F
Touch and hold this button combination again to
switch the electronic control indicator back to air
extraction mode (
E
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
B
symbol.
Setting the brightness
Press and hold the
symbol until the required
B
brightness is reached.
Audible signal
Switching on the audible signal
Touch and hold the
#
same time for approximately three seconds when the
fan is switched off. An audible signal sounds as an
acknowledgement.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
8
F
Cleaning and maintenance
symbols at the same time
+
light up. If the
F
indicator).
and
C
symbols at the
2Cleaning and maintenance
:
Warning
t e n a n c e
C l e a n i n g a n d m a i n
Risk of burns!
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
:
Warning
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
.
:
Warning
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Cleaning agents
Observe the information in the table to ensure that the
different surfaces are not damaged by using the wrong
type of cleaning agent. Do not use
harsh or abrasive cleaning agents,
cleaning agents with a high concentration of alcohol,
hard scouring pads or sponges,
high-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.