Electrolux # Manuale di istruzioni per l'installazione - Pagina 8

Stampa la pagina

Electrolux # Manuale di istruzioni per l'installazione

30" GAS RANGE INSTALLATION INSTRUCTIONS

Operation of Oven Burners and Oven

Adjustments

8.1 Electric Ignition Burners

Operation of electric igniters should be checked after

range and supply line connectors have been carefully

checked for leaks, and range has been connected to

electric power.

The oven burner is equipped with an electric control

system as well as an electric oven burner igniter. If your

model is equipped with a waist-high broil burner igniter,

it will also have an electric burner igniter. These control

systems require no adjustment. When the oven is set to

operate, current will flow to the igniter. It will "glow"

similar to a light bulb. When the igniter has reached

a temperature sufficient to ignite gas, the electrically

controlled oven valve will open and flame will appear

at the oven burner. There is a time lapse from 30 to 60

seconds after thermostat is turned ON before the flame

appears at the oven burner. When the oven reaches the

display setting, the glowing igniter will go off. The burner

flame will go "out" in 20 to 30 seconds after igniter goes

"OFF". To maintain any given oven temperature, this cycle

will continue as long as the display is set to operate.

After removing all packing materials and literature

from the oven:

a) Set the oven to BAKE at 300°F. See Use & Care Guide

for

perating instructions.

b) Within 60 seconds the oven burner should ignite. Check

for proper flame (see 6.2), and allow the

once (see cycle explanation above). Reset controls to off.

c) If your model is equipped with a waist-high broiler

burner, set oven to broil. See Use & Care Guide for

operating instructions.

d) Within 60 seconds the broil burner should ig

for proper flame (see 6.3). Reset controls

Lower

Oven Burner

Baffle

(removable)

Figure 11

urner to cycle

ite. Check

o off.

Waist-High Burner

Air Shutter

Lower Oven Bottom

Air Shutter

(removable)

8.2 Oven Burner Flame Adjustment

The approximate oven burner flame length is 1 inch

(distinct inner cone of blue flame).

To determine if the oven burner flame is proper, remove

the oven bottom and burner baffle and set the oven to

bake at 300°F.

To remove the oven bottom, remove oven hold down

screws at rear of oven bottom. Pull up at rear, disengage

front of oven bottom from oven front frame, and pull the

oven bottom out of the oven. Remove burner baffle so

that burner flame can be observed.

If the flame is yellow, increase air shutter opening size (see

"2" in Figure 12). If the entire flame is blue, reduce the air

shutter opening size.

To adjust flame loosen lock screw (see "3" in Figure 12),

reposition air shutter, and tighten lock screw. Replace oven

bottom.

Lock Screw

Air Shutter

Figure 12

6.3 Broil Burner Flame Adjustment

The approximate flame length of the burner is 1 inch

(distinct inner cone of blue flame). To determine if the broil

burner flame is proper, set the oven to broil. If flame is

yellow, increase air shutter opening size (see "2" in Figure

12 ). If the entire flame is blue, reduce the air shutter

opening size. To adjust, loosen lock screw (see "3" in

Figure 12), reposition air shutter, and tighten lock screw.

When All Hookups are Complete

Make sure all controls are left in the OFF position.

Before You Call for Service

Read the Before You Call for Service Checklist and

operating instructions in your Use and Care Guide.

It may save you time and expense. The list includes

common occurrences that are not the result of defective

workmanship or materials in this appliance.

Refer to your Use and Care Guide for Electrolux Service

phone numbers, or call 1-877-4ELECTROLUX (1-877-

435-3287).

Oven Burner Tube

Orifice Hood