Drill Master 40070 Manuale d'uso e istruzioni di sicurezza - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso e istruzioni di sicurezza per Sander Drill Master 40070. Drill Master 40070 12. Orbital hand sander
Anche per Drill Master 40070: Manuale di montaggio e istruzioni per l'uso (13 pagine)
Stampa la pagina
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy
REVENT SERIOUS INJUR FROM A
REVENT SERIOUS INJURy
Make sure that the Switch is in the off-position and unplug the tool from
its electrical outlet before adjusting tool or installing accessories.
Attaching Sandpaper to the Backing pad (28)
1. Press the tab on the clamps (6)
inward on both sides of the unit and
swing the clamps on both sides up,
out, and down. See 1 & 2, right.
2. Cut the sandpaper to fit the
1
4" W x 4
/
" L pad (28), with a little extra
2
to overlap and fit under the clamps (6).
Do not use torn or frayed sandpaper.
3. After wrapping the overlapped edges
of sandpaper under the clamps (6),
snap the clamps (6) back into place.
Workpiece and Work Area Set Up
1. Designate a work area that is clean
and well lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord
to possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
General Operating Instructions
1. Make sure that the Switch is in the
off position, then plug in the tool.
off-
off-
2. Turn on the Switch.
3. Run the Sander for a few seconds
before contacting the workpiece.
4. Contact the workpiece with minimal pressure.
Use sandpaper with a lower grit number
to remove material faster.
Item 40070
y FROM A
y
ccIDENTAL OpERATION:
For technical questions, please call 1-800-444-3353.
y
y INFORMATION
section
Sandpaper
goes under
here
3. Secure loose workpieces using a
vise or clamps (not included) to
prevent movement while working.
4. There must not be objects, such
as utility lines, nearby that will
present a hazard while working.
Note: All orbital sanders leave sanding marks
on the workpiece. To minimize sanding marks,
always try to sand with the grain of the wood.
5. Occasionally check the sandpaper for tears,
wear, or fraying. Replace if necessary.
6. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children's reach.
Page 9