AirTechnic LOOP WL100 Funzionamento e montaggio - Pagina 4

Sfoglia online o scarica il pdf Funzionamento e montaggio per Ventilatore AirTechnic LOOP WL100. AirTechnic LOOP WL100 5. Loop fan

X
INDEX
Ø
LOOP WL100 100
LOOP WL125 125
LOOP MODEL DESIGN (Fig.1)
LOOP series extraction fan includes body
1 with mounted motor and propeller.
Control plate is mounted in the central
ow section (protected by cover 3,
mounted with screws 4). Part 5 is xed to
the front part of the body and serves to
insert the power supply cable. Power
supply cable is protected by the cover 2.
The device and the inlet are protected by
masking front 6.
Preparations for fan mounting should
start with taking o the masking front 6
(snap-in mounted)and cover 2. Next,
power supply cable opening should be
made in part 5. Last preparation step
before mounting the fan is driving screws
4 to make it possible to take cover 3 o
and access control plate with power
terminals.
Warning !!! LOOP WL100R, WL125R model has a movement detection sensor attached with a tape to cover 3 -
remain cautious not to damage the connecting tape (it is recommended to take the cover o after mounting
the fan in the ventilation duct).

MOUNTING INSTRUCTIONS

• place the prepared fan body in a
ventilation duct - mark mounting
openings
• make openings for anchors and
space them equally to the openings
on the fan body
• place the fan in the ventilation duct,
inserting the power cable through
the opening made in the body
beforehand
X
Y
A
160
160
125
200
200
153
Operating Range
Capacity [m³/h]
Power [W]
Power supply [V]
Rated Frequency [Hz]
Protection Rating
Z
W
B
C
125
109
153
137
3
4
6
LOOP
C
A
D
Z
109
76
137
77
1
5
2
Fig. 1
Ø100
Ø125
I
II
I
55
85
120
3,3
4,6
7
230
50
IPX4
W
102
102
II
165
10