Bose 802 C II Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti Bose 802 C II. Bose 802 C II 22. System controllers
Anche per Bose 802 C II: Manuale di servizio (20 pagine), Manuale di servizio (23 pagine)

Stampa la pagina
Bose 802 C II Manuale d'uso
From
controller
Shield
+
–
Connections from the systems controller to an
amplifier with balanced inputs.
From
controller
Shield
+
–
Connections from the systems controller to an
amplifier with unbalanced inputs.
Amplifier
input
Shield (no
connections)
Figure 14
Amplifier
input
Shield (no
connections)
Figure 15

5.4 output Connections

In a full-range system that includes only 40
loudspeakers, use the controller's HIGH FREQ OUTPUT
jacks to drive the amplifier(s) feeding the loudspeakers.
Do not use the LOW FREQ OUTPUT jacks. The MODE
+
switch should be set to Mode (FR).
–
In a bi-amplified system, use the controller's HIGH
FREQ OUTPUT jacks to drive the amplifier(s)
– (GND)
feeding the high frequency loudspeakers (40
or 80 loudspeakers). Connect the LOW FREQ
OUTPUT jacks to the amplifier(s) driving the bass.
If the system has mono bass, use only the Channel
(left hand) LF output jack, and make sure that the
OUTPUT MODE switch is set to SUM.
For best audio performance, install all mixing or signal
processing equipment before the controller in the
audio chain. The 40C or 80C II systems controller
should be the last device in the audio chain before
the amplifier(s).
+
Here is how to wire the HIGH FREQ OUTPUT and
LOW FREQ OUTPUT jacks on the controller. When
– (GND)
the OUTPUT MODE switch is set to SUM, use only
the CH/SUM (left-hand) LOW FREQ OUTPUT jack.
NOTE: The pin numbers for each controller output
are shown in small type inside the jacks.
If the amplifier has balanced inputs (see Figure 4):
1. Connect the controller's PIN (+) output
terminals to the amplifier's hot, tip, or high
terminals. (These are usually pin on XLR-
equipped amplifiers).
2. Connect the controller's PIN 3 (-) output
terminals to the amplifier's low, ring, or minus
terminals. (These are usually pin 3.)
3. Connect the controller's PIN GND output
terminals to the cable shield and to PIN (XLR)
or ground at the amplifier.
If the amplifier has unbalanced inputs (Figure 5):
1. Connect the controller's PIN (+) output
terminals to the amplifier's hot, tip, or high
terminals.
2. Connect the controller's PIN 3 (-) output
terminals to the amplifier's shield or ground
terminals. Use one of the two cable conductors.
3. Connect the controller's PIN GND output
terminals to its cable shield. Do not connect at
the amplifier end.
or 80
TM
®