Bose SOUNDLINK REVOLVE Manuale di risoluzione dei problemi - Pagina 6

Sfoglia online o scarica il pdf Manuale di risoluzione dei problemi per Altoparlanti Bose SOUNDLINK REVOLVE. Bose SOUNDLINK REVOLVE 9. Resetting the speaker
Anche per Bose SOUNDLINK REVOLVE: Manuale d'uso (30 pagine), Manuale d'uso (30 pagine), Azzeramento manuale (2 pagine), Manuale di risoluzione dei problemi (12 pagine), Risoluzione dei problemi (4 pagine), Faq (3 pagine), Manuale di avvio rapido (2 pagine)

Try turning off Wi-Fi® on the device

Go to Bluetooth settings on your device, select the SoundLink® speaker and choose to "Forget"

or "Remove" the speaker. Next, briefly hold the Bluetooth button on the speaker until

the Bluetooth light begins flashing Blue. Then try again to pair the device to the speaker

Turn the speaker off and back on

Disable Bluetooth on other connected devices that are not currently in use. The speaker will pair

to the two most recently used devices in its memory. Sound might drop out if a second connected

Bluetooth device goes out of range of the speaker

Reset the device you are trying to pair. This is typically done by rebooting/restarting it or

removing the battery and/or power cable for one minute

Reset the speaker by turning it on and then holding the power button for 10 seconds until it turns

off

A factory reset clears the speaker's language setting and its paired mobile device memory,

returning the speaker to original factory settings. Once reset, turn the speaker on and try again to

pair the device.

Check for and install any software updates for your SoundLink® speaker at

global.Bose.com/support

Try pairing another device. If the other device works, there may be an issue with the first device

Bluetooth® device will not reconnect to the

speaker

Applies to:



SoundLink Revolve Bluetooth® speaker



SoundLink Revolve+ Bluetooth® speaker



SoundLink Micro Bluetooth® speaker

If your Bluetooth device will not reconnect to the speaker, try the following to pair your device:

If your device asks for a passcode to connect, make sure the one you entered is correct. If you

never set a passcode, enter 0000 (four zeros)

Make sure Bluetooth is turned ON on your device