Alert Systems HyperGuard MP10D Manuale - Pagina 5
Sfoglia online o scarica il pdf Manuale per Pager Alert Systems HyperGuard MP10D. Alert Systems HyperGuard MP10D 9.
Stampa la paginaWorld leader in metal detection for anti-shoplifting purposes
3. ADJUSTMENTS
3.1 Pager receiver programming
Receiver ON/OFF
Manuel alarm reset
Automatic alarm reset
Repeat of the latest alarms
Vibrator and beeper ON/OFF
Coding of extra receiver
900-1003114 Alert HyperGuard Quick pager MP10D (English V1)
ON: Press On/set.
Two beeps and a vibration are indicated (if enabled).
The LED's shows a running light from left starting with
and
red
Every 10 seconds a short flash in the
is ON
OFF: Press On/set and keep pressed until the LED's shows a running
light starting with
red
to blue.
One beep and a vibration are indicated (if enabled).
The receiver shows an alarm by a flashing LED, a sound and a vibration.
Press and hold OK 2 seconds to reset the alarm.
Connect the receiver to the adaptor.
Press OK and Menu at the same time for 3 seconds
Two short beeps are heard and vibrator vibrates twice =
Automatic reset ON.
Info in display: MSG TO ON
One short beep is heard and vibrator vibrate once =
Automatic reset OFF.
Info in display: MSG TO OFF
The latest ten alarms are stored in the memory in the receiver.
Press once on Menu shows the latest alarm.
Press twice on Menu shows the second latest alarm. And so on.
Connect the receiver to the adaptor.
Press OK, the vibrator vibrates once = Vibrator OFF.
In display: VIBR. OFF
Press once again OK, the vibrator vibrates twice = Vibrator ON.
In display: VIBR. ON
Press Menu, the buzzer beeps once = Buzzer OFF
Info in display: BUZZER OFF
Press once again Menu, the buzzer beeps twice = Buzzer ON
Info in display: BUZZER ON
There are no limit in numbers of receivers that can receive info from one
Transmitter. They only have to be coded to the transmitter.
Make sure that the receiver is OFF.
Press On/set and immediately (while LED's shows a running light) after
press OK until the
blue
and the
Within 5 seconds press TEST on transmitter.
(Blue
led next to TEST bottom flashes)
Info in display: ASSIGN HOME ID
If the coding is OK two short beeps are heard.
If the coding fails one short beep is heard.
blue, yellow,
green
LED shows that the receiver
red
LED's are flashing.
Page: 5/9
Date:May 31, 2013
green