Bose 901 Manuale d'uso - Pagina 17

Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti Bose 901. Bose 901 20. Vi direct/reflecting speaker system
Anche per Bose 901: Manuale d'uso (41 pagine), Manuale d'uso (23 pagine), Istruzioni per il montaggio e l'assemblaggio (1 pagine), Manuale d'uso (12 pagine), Manuale di installazione e funzionamento (15 pagine)

One speaker sounds

defective, or does not play

Neither speaker plays

The high and low

frequencies seem weak

You hear distortion

at high volume levels

The trouble seems to be in

the 901 active equalizer

Trouble persists in the

speakers or equalizer

If your 901

speakers have a painted surface, clean with a soft damp cloth. If necessary, use

a mild detergent such as dish soap. If the speakers have a wood veneer ﬁnish, clean them

with wood furniture polish. You may vacuum the speaker grille panels carefully, if necessary.

Do not use any sprays near the system. Do not use any solvents, chemicals, or cleaning

solutions containing alcohol, ammonia, or abrasives. Do not allow liquids to spill into any

openings.

If you have a problem with your 901 Series VI speakers or 901 active equalizer, turn off the re-

ceiver or ampliﬁer before you proceed. Then check all the connections between the speakers,

receiver, and active equalizer. Correct any wiring problems before you follow the guidelines

below. Problems are more likely to originate with equipment other than speakers, so you may

also want to refer to your receiver or other component owner's guides.

• Do not switch the wires; this could damage a speaker. Turn off the ampliﬁer and disconnect

the defective speaker wire at the ampliﬁer. Reconnect it to the other channel. If the speaker

now plays correctly, the problem is not in the speaker or wiring.

• Connect the speakers to another receiver or ampliﬁer that is known to be operating

properly. If the speakers now play correctly, the problem is not in the speakers.

Note that the tonal balance of the 901 speakers will be incorrect if the 901 active equalizer

is not being used with this second receiver or ampliﬁer.

• Check to be certain that the 901 active equalizer is in the circuit. Review the Playing

your speakers section of this guide on page 14.

• Try turning down the volume. If the distortion goes away you may be using an insufﬁciently

powered receiver or ampliﬁer.

• Bypass the equalizer to see if the system operates properly without it. (Speakers will not

have any highs or lows.) Check to see that all connections are correct and that none of

the cables is defective.

• Contact your authorized Bose

a factory authorized agency or by the Bose factory. Bose Corporation will make every

effort to remedy any problem within the terms of the warranty.

dealer to verify any defects and arrange for service by