Advanced Radiant Systems Cool-Space CSW-12-VD Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Pulitore d'aria Advanced Radiant Systems Cool-Space CSW-12-VD. Advanced Radiant Systems Cool-Space CSW-12-VD 19.

Stampa la pagina

There are 4 factors to consider when determining where to place your evaporative cooler.

1. Fresh air supply: The inlet side of the unit (pad side) requires a constant, uninterrupted supply of fresh air for

maximum performance. A distance of 3 ft. of clear space is recommended.

2. Discharge airflow: The cool air discharged from the unit should be free of obstruction to allow the air to

circulate in order to maximize the cooling zone.

3. Ventilation: Allow cooled air to circulate away from discharge area of cooler. This ensures that the unit does

not re-circulate air that has already been through the evaporative cooling process.

4. Placement: The unit must be placed on a level surface to operate correctly. The units create an oval shaped

air pattern that can reach out as far as 20 feet. Obstacles such as racks and workbenches may interfere with

the cooling zone. An attempt should be made to locate the unit in such a manner that interruption of the air

pattern is held to a minimum. Multiple units may be required to cover large areas.

Initial start-up:

Clean out the Sump:

material in the sump before start up. It is normal

for some debris to accumulate in the sump. It is

best to flush out the sump with water to clear any

debris.

Filling the unit with water:

has been hooked up to a water source, turn the

water supply valve on and the unit will fill with

water. The float valve will shut off the water flow

when the reservoir is filled.

Starting the pump:

pump switch may be turned to the 'ON' position.

Initial Washing of the Cooling Media:

the pump without any airflow through the media. This washing action will clean out any debris in the media

as well as reduce any odor and improve wetting ability.

Break in Period for Cooling Media:

100 hours of operation. The chemical constituency rigidifying agents in the media will then be set and will

not leach out further. Ignore any coloration in the water during this initial period.

If a strong odor persists, run the pump to flush the media with water, without airflow through the media, until

the odor disappears.

Annual start-up:

At the beginning of each cooling season follow the same procedures as the initial start-up with some possible

exceptions. If the media was removed for the winter, it will have to be replaced (note instructions below on media

replacement). Check the condition of the media. If the flutes of the media are clogged with buildup of alkali deposits or

are otherwise damaged, consider replacing the media. This is the best time to make this decision while the unit is not

being used and may not be as critically needed.

Page 9 of 16

START-UP PROCEDURE

Do not operate the pump when the reservoir is dry. This will cause the pump to

fail and also void the warranty.

Remove any foreign

Once the unit

Allow the reservoir to fill before turning the pump on. Once the reservoir is full, the

The media will reach its peak operating condition after about

ELECTRICAL SHOCK HAZARD

•

The media should be washed for several hours by running

Serious injury or death may

occur.

Disconnect from electrical

supply before servicing this

product