Bose SoundLink Bluetooth Mobile Speaker II Risoluzione dei problemi

Sfoglia online o scarica il pdf Risoluzione dei problemi per Cuffie Bose SoundLink Bluetooth Mobile Speaker II. Bose SoundLink Bluetooth Mobile Speaker II 4. Around-ear wireless headphones ii
Anche per Bose SoundLink Bluetooth Mobile Speaker II: Manuale d'uso (24 pagine), Manuale d'uso (16 pagine), Manuale d'uso (28 pagine), Manuale d'uso (34 pagine), Manuale d'uso (32 pagine), Manuale di risoluzione dei problemi (12 pagine), Faq (2 pagine), Domande e risposte (4 pagine), Faq (2 pagine)

If your Bluetooth device will not reconnect to the speaker,

try the following to pair your device:

If your device asks for a passcode to connect, make sure the one you entered is

correct. If you never set a passcode, enter 0000 (four zeros)

Make sure Bluetooth is turned ON on your device

Try moving your device closer to the speaker. Bluetooth range is about 9 metres.

Range is reduced when interference is present, like walls or multiple Bluetooth

devices in the same area

If two Bluetooth devices are already paired to the speaker, disable Bluetooth on one

of the devices, or take it out of range of the speaker. The speaker remembers the

last eight paired devices but can only pair to two devices at a time

Repeatedly press the speaker's Bluetooth button until you hear the name of the

desired device

Go to the Bluetooth settings on your device, select the SoundLink® speaker and

choose to "Forget" or "Remove" the speaker. Next, briefly hold the Bluetooth

button on the speaker until the Bluetooth light begins flashing Blue. Try again to

pair the device to the speaker

Reset the device you are trying to pair. This is typically done by

rebooting/restarting it or removing the battery and/or power cable for one minute

Clear the SoundLink® speaker's paired device memory by holding the Bluetooth

button until you hear a tone and, if enabled, a voice prompt. The speaker's

Bluetooth light begins flashing Blue. Try again to pair the device to the speaker

Reset the speaker by turning it on and then holding the power button for 10

seconds until it turns off