ABSCO SHEDS ADGAZEBO63 Manuale - Pagina 9

Sfoglia online o scarica il pdf Manuale per Arredamento per esterni ABSCO SHEDS ADGAZEBO63. ABSCO SHEDS ADGAZEBO63 14. Signature gazebo

SIDE FLASHING - FRONT DETAIL

SIDE FLASHING - REAR DETAIL

Absco Industries

Assembly Instruction Manual

ABSCO SIGNATURE GAZEBO

MODEL: ADGAZEBO63

6.12m W x 3.11m D x 2.60m H

NOTE:

Leave the protective plastic on TR36 flashing until

fastening, It's good to mark on.

Do one TR36 as pictured - the other TR36 is the

same but 'mirrored'.

1. Mark out and cut away 15mm from the top

and bottom sides using tinsnips (offcuts shown in

grey).

2. You'll be left with a tab as shown. Use "Sheet

Metal Locking Pliers" to easily fold it 90 degrees.

3. Check fit by placing flashing along the edge of

roof panel.

• Bent tab hard up against end.

• Top face sits on two sheet ribs.

• Bottom face covers the Z flashing.

UNDERSIDE VIEW - Beams not shown.

0. TR36 flashing will overhang roof panel at the

rear and we'll need to trim to make the gutter fit

later.

NOTE: If the flashing is the same length as the

roof panel you don't need to trim the top.

1. Mark off where 'top skin' end is against the top

side of the TR36 flashing.

Then continue 30mm down the side.

2. Mark off where the rear 'Z' flashing is against

the bottom side of the flashing.

Then continue 40mm up the side.

3. On the side mark a line to join these points as

shown.

4. Take the flashing down off the roof and trim

using tinsnips (offcuts shown in grey).

Model: ADGAZEBO63

4/12/23

1.00