Maintaining Your Acoustic Wave
Cleaning
Replacing the remote control battery
Figure 21
Battery removal and
installation
22
®
Use only a soft dry cloth to clean the enclosure of your Acoustic Wave
necessary, you may use a soft-bristled attachment to gently vacuum the front of the enclo-
sure. Do not use any liquid cleaning solutions, solvents, chemicals, alcohol, ammonia, or
abrasives.
CAUTION: Do not allow liquids to spill into any openings in the enclosure. If liquids get into the
unit, turn it off immediately. Call Bose
service. See the list of phone numbers inside the back cover.
Your remote control comes with the battery installed. When you need to replace an expired
battery, refer to the following steps.
1. Place the remote control face down on a flat surface.
2. Using your finger, push the tab lock to the side as shown and hold. Slide the battery
compartment open.
3. Keeping the remote control face down, insert the new battery into the compartment with
the + symbol facing up.
4. Gently slide the battery compartment closed. It locks automatically.
Tab
WARNING: Keep the remote control battery away from children. It may cause a fire or chemical
burn if mishandled. Do not recharge, disassemble, heat above 212º F (100º C), or incinerate. Dis-
pose of used batteries promptly. Replace only with a battery of the correct type and model number.
WARNING: Danger of explosion if battery is incorrectly replaced. Replace only with Duracell,
Eveready, Energizer, Maxell, Toshiba, or Shun Wo CR2032 or DL2032 3-volt lithium battery.
Music System II
®
Customer Support as soon as possible to arrange for
®
music system II. If
+
Symbol